Question about Televison & Video

1 Answer

I have a 42 inch Philips Plasma and when you turn it on from standy it comes on for a few seconds and then goes back to standby and the red led on standby flashes continusously.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

Have the main power supply checked

Posted on Aug 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi. I have a problem with my 42 inch plasma tv,when tv is turned on green L.E.D appears on bottom right and tv works as normal.After 40 minutes to an hour tv makes click sound and screen goes blank the...


Hello, A common problem for these is bad capacitors in the power supply, Remove the back from your Tv and look at the power supply on the left hand side.
You will see roughly around 9 x capacitors that are bulged / domed shaped on top usually these are valued at 3300uf 10V any that have bulged or leaked a brown like substance should be changed. This will cure the problem as they overheat being sat next to a heatsink that gets very hot! Try and change them for the same 3300uf but a higher voltage.
I hope that this help to rectify the fault of the projection TV....

May 12, 2011 | Televison & Video

1 Answer

I have a philips dlp 55pl9773 has one red flashing led on the front when i do a hard reset tv boots up lamps lites led goes from flashing yellow to green for about ten seconds and then back to red flashing...


MY philips tv model number 55PL9773/17 WAS TURNING OFF THE SCREEN AND LEAVING THE AUDIO ON FOR ONE MINUTE. THEN THE YELLOW LIGHT STAYED ON. THEN THE LIGHT TURNED OFF. thEN I TURNED ON WITH THE REMOTE AND THE YELLOW LIGHT TURNED ON AND A FEW SECONDS LATER CHANGED TO THE GREEN LIGHT AND THE TV TURNED ON. AFTER A FEW MINUTES, BETWEEN 10 AND 30 IT DID THE SAME THING. NOW IT IS OFF WITH A BLINKING RED LIGHT PERMANENTLY ON. TO TURN IT OFF I HAVE TO UNPLUG IT FROM THE WALL. I REPLACE THE LAMP A FEW WEEKS AGO AND IT IS FINE.

Dec 01, 2009 | Philips 55PL9773 55" Rear Projection...

1 Answer

Plasma wont turn


unplug it and leave it off for 10 mins
then plug it back in.

Aug 18, 2009 | Televison & Video

1 Answer

LG PLASMA 42 INCH WONT TURN ON!


Sure, you will need to replace the power supply circuit board asap. this will fix your issue.

Jun 03, 2009 | Mitsubishi WS-65513 65" Rear Projection...

1 Answer

FLASHING POWER RED BUTTON 7 TIMES


I believe that is a bad power supply board. You can unplug set ,open the back access panel and look for swollen electrolytic capacitors they will most likely be slightly rounded on top instead of flat top like the others.Not sure if just replacing caps is enough we mainly swap out whole board.Some models' replacement power supply is slightly different from original in that a couple of the plugs are in different spots and require an extension cable.

the tv dude

Apr 01, 2009 | Sony KDS-R50XBR1 50" HDTV

1 Answer

Soniq plasma will not power up


1.8 volt regulator on image pcb

Jan 08, 2009 | Televison & Video

1 Answer

POP goes the Plasma


You've lost the standby voltage, probably due to varactor or passive component failure...accordianman

Feb 26, 2008 | Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

69845 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6393 Answers

yadayada
yadayada

Level 3 Expert

64034 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...