Hi there many thanks for asking about monitor rolling, it has now been sorted after putting new batteries in mouse also the wheel on mouse needs cleaning.
regards jowigz wales
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
yes. it is almost positively the video card. you can get a PCI video card and install that in an open slot. if you don't need to play games, you don't need a fancy one, just a basic card.
maybe one of the buttons is stuck? a short circuit in the button is definite to cause that... i shocked my last monitor and it started doing that. I had to buy a new monitor, because my tech couldn't fix it because it was arcing
turn off the cop and unplug all the cables and open the comp tower and remove all memory chip and turn on the comp by plugging just the power cable and leave the comp on for 2-3 min and the comp will beep and thn turn off the cop and pull the power out and put the memoy chips back in the comp and plug all the cables asnd then turn on the comp anf the issue resolved le me know if any problems at [email protected]
Memory Installation Guidelines
if you change you graphic card make sure that the monitor that you are using can hold a higher pixel for exam ple your monitor can hold up to 800 x 600 and you change it to 1024 x 768 it wont work your monitor will turn off itself because it can only hold a lower pixel find a monitor that can hold more than you want hope it help. send me a message for more concerns..ty
There should be a setting within the comp. Is it connected to the comp monitor and the tv? Perhaps from the comp to the tv with the monitor from the comp as well? Well if so, you may need a certain setting within the comp. Check under (on xp) display properties, and then under the settings tab. Please rate!
Try to use another keayboard, if that dosent work, try to do a full >CMOS reset.
error 25 is a weird 1 as although it's supposed to relate to gfx it's also been seen to be apparently associated with faulty IDE cables/drives & even keyboards
Turning you rmonitor on then your comp my monitor has a delay and if i dont turn it on before i turn my comp on or before i here the little beep noise my comp makes the monitor wont display anything.
×