My cd rom drive wont quit going in and out its saying that i have it disabled but clearly i dont HELP

This issue may occur if one of the following conditions are true:

• There is a configuration issue with the CD-ROM drive.
• The MDAC (Microsoft Data Access Components) is damaged or is not installed properly.
• There is an issue with the CD-ROM media. For example, the program CD-ROM is damaged or dirty.

Solution:

• Examine the CD-ROM or DVD Disc
• Clean the Program CD-ROM or DVD
• Test the CD-ROM or DVD in another Drive
• Clean the Drive
• Quit Unnecessary Software
• Look for Known Issues with the Drive or Recording Software
• Check for Drive Firmware Updates
• Make Sure That You Are Using Protected Mode CD-ROM Drivers
• Enable and Disable UDF Support
• Reduce Drive Caching
• Disable Auto-Insert Notification
• Remove Duplicate Drives]
• Restart Windows in Safe Mode
• Clean Boot Your Computer
• Install the MDAC Update
• Check for Alternate Installation Locations

if problem persist contact game manufacturer.

Click on the start menu in the lower left corner of your display.
Click on "My Computer".




A window similar to this one will open and you will see your CD/DVD drive.


If double clicking the drive does not open the CD, right-click the symbol with your mouse and choose "Play" or "Open".

If you have any more questions, just come back here and leave a comment - I'm happy to help.

i have a mitsumi cd rom drive. will this drive burn mives

You might have multiple problems. Are you sure the CD-Rom works? It is not uncommon for CD-ROM drives to go bad in laptops. If it was bad before and then the hard drive became corrupt all before it was given to you then you would have no way of knowing. This would explain why you do not get the Press Any Key to Boot From CD on boot.

There is no doubt that the hard drive image is corrupt, so the first thing I would check is the CD drive and go from there.

From the device manager, Right click on the drive and uninstall it. Then restart your computer. See if that helps.

If still not, then you can try this step.

1) Close all open programs
2) Click on Start, Run, and type REGEDIT and press Enter
3) Click on the plus signs (+) next to the following folders

* HKEY_LOCAL_MACHINE
* SYSTEM
* CurrentControlSet
* Control
* Class
* {4D36E965-E325-11CE-
BFC1-08002BE10318}

4) This folder is the DVD/CD-ROM Drive Class Description in the registry. Look for any of the following names in the right hand column.

* UpperFilters
* LowerFilters
* UpperFilters.bak
* LowerFilters.bak

5) If any of the above keys shown in step 4 are listed, right-click on them and choose Delete
6) After deleting the keys, close the Registry Editor
7) Reboot your computer

Eveidently you disabled the CD from within control panel. I'm assuming you are familiar with windows, so I'm just going to give the buttons you press. Do the following:

Start(bottom left of screen)>Setting>Control Panel>System>Hardware>Device Manager>DVD/CD Rom Drives +>Click on your CD and select use this device (enable) down in the bottom of the box.

Press OK and close all the boxes and see if the device appears in your safely remove hardware dialogue.

If not, go to HP.com, select downloads and find the driver for your CD and reinstal.

This should clear it up.

Good luck!!

After format your computer will not boot if don't have the Sys files on it. Try to put your hard drive back to your computer and start booting with some cd with hard drive utilities like http://www.ultimatebootcd.com/

delete the upper and lower filter fo cd dvd drive from registry editor
and restart the system

i cnt run my dvd rom drive but only cd.disk

Check the SATA/RAID controller setting. It could have been set to [Disabled] Refer to your user?s manual for a detailed description on how to enable the onboard SATA/RAID controller by adjusting the jumper or BIOS settings. Regards SparkGap