Microsolutions external backpack

looks like it is 12 V, 1 to 2 amp.

her are some power Adapters listed on amazon. Also, look on the bottom to see what polarity it is (also by mosue over the picture of the adapter in the bottom link (to zoom in)

Amazon com Pwr Extra Long 6 5Ft Cord AC Adapter Charger for Seagate Hdd...


Amazon com Super Power Supply AC DC Adapter Charger Switching Cord Plug...

Hi, I think I found one for you 5V AC DC power adapter for SIMPLETECH 96200 41001 075 250GB USB hard... . If it is correct, it is OK to just find ANY power cord with Output Voltage: 5 Volts DC and Amperage: 1 Amps. It just need to fit in.

You're out of luck, Microsolutions went out of business long before the introduction of Windows 8.1. If this is a scsi drive, you will need the driver for the scsi card only. Once installed, the system will automatically pick up the drive during boot.

1) Use a multimeter, check the AC adapter (Charger) for power.
Make sure it is putting out the required voltage.

Have an assistant gently wiggle the cable FROM AC adapter TO laptop. See if there is an intermittent reading on the multimeter.

Have an assistant gently wiggle the power cord.

An intermittent reading on the multimeter indicates a broken wire.
Power cord is bad? Replace cord.
Cable from AC adapter to laptop is bad? Replace AC adapter.

If you have posted the laptop manufacturer NAME and MODEL NUMBER, I could have given you more than generic information.

Model Number is in the Bottom of the laptop. Post back in a Comment.

AC adapter works OK?

Check the DC Power Jack.
The DC Power Jack is the jack on the laptop, that the AC adapter plugs into.

DC Power Jack checks OK, this is your problem,

http://mayohardware.blogspot.com/2010/04/important-parts-on-dv6000-and-dv9000.html

Regards,
joecoolvette

1. See whether Chipset drivers have been installed.
2. Try replacing the USB Cable.
3. Check whether this HDD is detected in another system.(If it detects and works fine then get your system checked for USB port, else you external HDD is having problem.)

First does your bantam,have an adapter for 110,120.or 220 volts? Second is it three or two pringed? Third does your bantam have a battery? Fourth do you travel to europ a lot? Or asia,and have you used your bantam on battery power before? If so does your owner's manuel specifie the configuration of its usage ?

Hi , Click the below link and create a free login account and then access the below link to download Win 7 driver for your product.

http://members.driverguide.com/index.php?companyid=668&action=getinfo/

12 volts nominal.

It needs 12 V - 1.5 A and +in center.

I think it would get power through the Moniter so I don't think you need a power cord for the CPU. Hope this helped =)