Question about Dryers

Open Question

Bosch Logixx WTA 36 Dryer. After setting the programme on the control panel and pressing start it normally powers up and starts but all of a sudden it does not. The control panel works as normal and actually counts down as if the dryer is working through its programme.

Posted by on

6 Suggested Answers

maklean
  • 1665 Answers

SOURCE: Service Manual

http://www.servicetechhelp.com/index.php/downloads/6124

Posted on Jun 26, 2008

  • 91 Answers

SOURCE: Dryer problem

check your door switch problably broken reason why it does not start

Posted on Jan 03, 2009

  • 172 Answers

SOURCE: control panel looks ok but dryer wont start

Sounds like an electronic problem on the timer circuit board.

Posted on Aug 12, 2009

canbruce75
  • 1776 Answers

SOURCE: bosch tumble dryer, model wta 4100 , no heat,

If the dryer isn't heating, check for a blown thermal fuse or a faulty heating element. Both components can be tested using a multimeter or ohmmeter. Check for continuity. A lack of continuity indicates a faulty component. Both components are located in the rear of the dryer. The thermal fuse is about an inch long and is usually attached to or near the exhaust duct. Hope this helped and best wishes.

Posted on Sep 12, 2009

  • 2 Answers

SOURCE: Where do I find the reset button on the Bosch WTA

my dryer is blowing cold air it is a bosch 2000wta

Posted on Apr 07, 2010

  • 414 Answers

SOURCE: have a Bosch logixx condenser dryer. key sign on screen

You have activated the child lock, basically you have held the start button for over 3 secs. turn the dryer to the cycle you want and keep your finger on ther start button to deactivate. If this doesn't work you may have a module problem. Double check your manual for child lock info. if no module go to link and enter you Enr number.
https://portal.bsh-partner.com/portal(bD1kZSZjPTAwOQ==)/PORTALFRAME.HTM

Posted on Jul 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bosch logixx 10 tumble dryer


This is not a good sign. You should check to see if the door switch is bad. If it is not that then the controller needs replaced.

Jul 08, 2013 | Dryers

1 Answer

The dryer won't turn on. The fuses are good, the power is good, the condenser is good and the motor is good. The light on the panel come on but nothing happens. Is it the circuit board?



Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The
Dryer is not Turning

Dryer Repair - The
dryer will not start


heatman101

Feb 26, 2011 | Bosch Axxis WTA 3510 Electric Dryer

1 Answer

Bosch axiss dryer WTA3510US wont run checked power, fuses. i close the door hit start the drying light comes on but nothing happens no clicks noies's nothing. is it the relay board or somthing else?


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Sep 14, 2010 | Bosch Axxis WTA 3510 Electric Dryer

1 Answer

Have a Bosch logixx condenser dryer. key sign on screen


You have activated the child lock, basically you have held the start button for over 3 secs. turn the dryer to the cycle you want and keep your finger on ther start button to deactivate. If this doesn't work you may have a module problem. Double check your manual for child lock info. if no module go to link and enter you Enr number.
https://portal.bsh-partner.com/portal(bD1kZSZjPTAwOQ==)/PORTALFRAME.HTM

Jul 02, 2010 | Bosch Dryers

2 Answers

I press the start button, the light goes on but nothing happens


I had the same problem. It is the door latch. It cost about $150 to fix. I can't believe the tech didn't know it. It is very common for Bosch Dryers after about 3-4 years old.

Jul 11, 2009 | Bosch Axxis WTA 3510 Electric Dryer

3 Answers

Bosch Axxis Starts and stops


The lint light keeps coming on and shuts the dryer off so clothes are not dry. I checked the filter and it is clear. Now the bottom of filter is cracked (plastic part) so I need to replace. But why does the lint light come on now after 5 years of use? It never came on before even when the lint filter was full?

Apr 20, 2009 | Bosch Axxis WTA 3510 Electric Dryer

1 Answer

Drive Belt on BOSCH WTA 3003 dryer


No,It`s quite a difficult & fiddly job.

Nov 10, 2008 | Bosch Axxis WTA 3003 Electric Dryer

1 Answer

Bosch Dryer misfunction


Check the fuse. This is a German unit, so every part including the light bulb is 208/240 volts. If the fuse for the dryer on the back is open the unit will not start.

Nov 18, 2007 | Bosch Axxis WTA 3510 Electric Dryer

Not finding what you are looking for?
Dryers Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you a Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...