Question about Haier hwr10xc6 Air Conditioner
I have a haier esa412m that had that same code e0, in my case it was a loose solder connection for the thermal sensor in front of the evaporator behind the intake air filter, the board with the loose connection sits behind the control pad, you will need to remove the covers, both front and top/side, disconnect the main power board and look for bad solder connects and resolder them, takes about 45 mins if you are a little handy.
Posted on Dec 21, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: haier air conditioner
One thing you can try is to hold down on the power button and plug the unit in. Hopefully you will hear a "beep". Then you need to unplug it for a minute and plug it back in. This is a known procedure to clear error codes from the control computer on units similar to yours, so it might possibly work. Something else you can do is download and look through the Users Manual for your model, which is at this URL: --> http://www.haier.com/products/product.asp?proID=1797 Hope this helps! ;)
Posted on Aug 06, 2007
SOURCE: Haier air conditioner # HWR06XC6
I have the same air conditioner and have call Haier customer support and they are also unable to tell me where the drain is. The manual says not to drill holes in the trap but I think that is the only option.
Posted on Jun 10, 2008
SOURCE: My Haier 8,000 BTU air
I had that same problem, find the remote and use that to turn it on / off. It solved the problem for me, for whatever reason. You will need to use the remote until the buttons start working again, took mine a few days. I have no idea what was wrong with it.
Posted on Sep 06, 2008
Hi! You need to check pump filter. It could be jammed with a coin or hair clip. Now take the machine outside and empty it then lay it on its side and you can access the pump. Take it off, stand up the machine and pour hot water into the soap draw and check water should run out of bottom freely taking any fluff or bits with it. Now take apart the pump and clean it and dry all components before re-assembly. If the machine still doesn?t work then you need to replace the pump. Please do rate this solution as FixYa and revert for further assistance. Thanks Rylee
Posted on Jun 13, 2009
Tips for a great answer:
Sep 14, 2016 | Heating & Cooling
Apr 05, 2016 | Haier Heating & Cooling
Control displaying F3 E0:
There may be a problem with the Oven Temperature Sensor, or the associated wiring.
Power unit down by turning off the circuit breaker(s) for one (1) minute.
Power unit up by turning on the circuit breaker(s).
Monitor the oven for one (1) minute to ensure the error code does not display again.
Verify oven operation.
Jul 31, 2014 | KitchenAid KHMS155LSS 1000 Watts Microwave...
Oct 16, 2012 | Samsung HM500JI 500 GB SATA Hard Drive
Oct 06, 2011 | Haier hwr10xc6 Air Conditioner
Sep 18, 2011 | KitchenAid Ovens
Dec 08, 2010 | Heating & Cooling
2,657 people viewed this question
Usually answered in minutes!