Question about GE Kitchen Appliances - Others

1 Answer

I have my Moms GE Automatic skillet (CAT. No. C 100) perhaps 40-50 years old. The thermostat in the handle needs repair. Are patts still available and if so, where? Can I ship it for repair.

Posted by on

  • knotthoser May 26, 2011

    Thanks for your prompt reply. I have the original maintenance/cookbook phamphlet with very little info re part numbers. However, on the underside of the skillet, it sez: General Eletric Skillet CAT. No. 26C100 120 volts, 900 watts-AC only, Bridgeport, Conn. Skillet may be immersed in water up to indicator light> The phamphlet has a list of GE service centers nationwide. The closest to me (if still existing) are: 326 Broadway NY., 5554 Chestnut St. Philadelphia, Pa. I also bought a new plug-in for the handle, so, that is o.k. The temp. selector boils at 200 and the heat resistant knob gets very, very hot. Hope this helps.

  • knotthoser May 26, 2011

    I have the original phamphlet called the "Use and Care Book." It has no maint. parts or numbers. However, on the underside of the skillet bottom it has: General Electric Skillet" Cat. No. 26C100 120 volts 900 watts-AC only Bridgeport, Conn. Made in USA. Skillet may be immersed in water up to indicator light. The Use and Care Book lists many Service Centers nation wide the closest to me would be (if still existing) 326 Broadway,NY, NY and 5554 Chestnut St. Phila, Pa. I bought a new plug in so that is not the problem. The temp. selector is definitely gone as it will boil at 200 and the heat resistant handle becomes extremely hot at the plug in site. Hope this helps.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,015 Answers

As far as I can tell parts are not available for this skillet. If you can get me a model or part number I would be happy to do more looking. Thank you.

Posted on May 26, 2011

  • Jack Spooner May 26, 2011

    Thanks for the information. It will be awile before I can get to it as I have a Drs. Appt. this afternoon and I won't have a chance till this eve but I will get back to you. Thanks again and have a good day.

  • Jack Spooner May 27, 2011

    sorry for extended delay. I have checked in about every location tjat I know of and get the same response.This part is obsolete and no longer available.I know it is of little help to you but I did try. Thank you,Frodo959

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fridge compressor working constantly


You either have a bad thermostat or the defrost system is not working. This is not a repair the un-skilled homeowner can handle. Try to find an honest repair person. If it is several years old, may not be cost effective to have repaired. Average life of a new frig is in the 8 year range. Lucky if you get more. Older ones were better.

May 05, 2014 | GE Profile PSI23NCR Side by Side...

2 Answers

Am I able to find a temperature cord to replace the 169025 cord?


Apparently you're not the only person to have trouble obtaining this part. I've read that GE does not make the power cord / thermostat assembly available for purchase separately, but you could consult the GE support page to contact them directly to see if they have other options available to you.

I found a reference here on FixYa that someone else wrote about and they were provided the following number to call:

877-207-0923

This will connect you to the GE / Walmart customer service group. Apparently, you must have purchased the appliance at Walmart for this group to help you out. Of course, if you say you bought it at Walmart - and they never sold that model - you won't get any help. Apparently Walmart has a pretty liberal return / replacement policy, so it can't hurt to try.

I hope this helps and good luck. Please rate my reply, thank you.

Feb 24, 2011 | GE 169025 Non Stick Electric Skillet

1 Answer

I have an old Icebox and I was cleaning it and gas or some type of air started coming out of a hole in the back...what is coming out? Do I need a new fridge?


I'm going to guess you broke a freon line when you were cleaning it. It might have had a spot that was almost rusted through and when you cleaned it you knocked off what little protection it had left. If you weren't being rough with your cleaning, then chances are it would have blown through pretty soon by itself. To repair it, the freon line will have to be repaired and new freon and a drier installed. Since you said it was an "old" refrigerator, I don't think it would be cost effective to have it repaired. Depending on the availability of used units in your area, you could probably pick up one 4 or 5 years old for cheaper than the repair. Depending on the age(say 10 years old for arguments sake), you will have put around 100 bucks into it...but still have a 10 year old compressor, thermostat, etc. I picked up a 4 year old top mount for $150 a year ago.
Hope this helps, and remember the repair vs. replacement cost analysis is just my opinion

Jan 21, 2011 | GE Refrigerators

1 Answer

Need handles for vintage Presto pots. Handles measue 4", with screws being at 3-/8 - 3-1/4" centers. Where can I find them?


We bought a set pf pan about 40 years age and th handles have broken,look for new ones.
the paten # is 2502495.
ther are 18-8 stainles copper botom.

e-mail is csjslmr@juno.com

Nov 28, 2010 | Presto 06821 Electric Skillet

1 Answer

I NEED A CORD FOR MY GE ELECTRIC SKILLET


Hello there
You can usually get this cord at your local elecronics repair shop
or if you have a thrift store like good will ect ect
or if you have a walmart there they can get one too ok or simply contact the manufacture of the skillet ok?
best regards michael

Sep 14, 2009 | GE 106749

1 Answer

Broken leg - need replacements


bake lite is very hard to repair
but i ahve made this very repair using a varied amount of things with varied success
depending on where it broke yo may want to try gorilla glue
if clost to the bottom get som jb weld from your harware store this will do it it may not be prtty but it will work

May 10, 2009 | Kitchen Appliances - Others

1 Answer

Ice Maker Flooding- how to detach plug to replace


Dear friend,
ngfam at you service! happy to assist!

They are correct I pull them out 4 times a week!
Perhaps it is just jammed in withe corrosion or frozen!
If you failed to pull it out by hand, get a rubber handled channel lock and grab it tight and wiggle it a little as you pull or pry id out gently! THE ONLY WAY TO GET IT OUT ,EVEN IF SERVICE DOES IT WILL BE TO PULL THE PLUG OUT!!!!!!!!!

Perhaps you should try service!
We sell appliances for 65 years and I recommend this nation wide Factory repair service!

Call A&E Factory Service /They service nation wide
And are available 24/7 for making appointments!

If the appliance is 10 years old or more,it may make sense not to invest any money to fix it!

Happy to assist you,
PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF!

Aug 29, 2008 | GE GSS25JEMWW Side by Side

2 Answers

GE 106749 handles


I need a replacement handle for model #S16G skillet as I dropped it and broke handle with attached leg.

Oct 15, 2007 | Kitchen Appliances - Others

Not finding what you are looking for?
Kitchen Appliances - Others Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Kitchen Appliances - Others Experts

John Tripp
John Tripp

Level 3 Expert

4654 Answers

Charles T Nevin
Charles T Nevin

Level 3 Expert

4070 Answers

Sal DeAngelo

Level 3 Expert

2333 Answers

Are you a GE Kitchen Appliances - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...