Question about Gaggia Syncrony Logic 74884 Espresso Machine & Coffee Maker

1 Answer

Gaggia Syncrony Logic Dispenser drive operating a slow speed

The dispenser drive unit is not capable of turning the dispenser through the start up sequence. I have removed the dispencer and tripped the door & tray switches to observe the the dispenser drive shaft and when you turn on the machine the shaft turns very slowly and sounds as if it is stalling.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I need a manual also.

Posted on Dec 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Gaggia Syncrony logic rapid steam machine leaks water from bottom


Check the chamber under the white plastic valve behind the brew unit, it might be blocked with coffee.

Apr 13, 2010 | Coffee Makers & Espresso Machines

1 Answer

Where can I purchase a replacement dispenser shute for Gaggia Synchrony Logic Type SUP 020 Ser.#9005GA40015808? Many thanks.


Check the site at importika.com they have a list of repair areas any one of them will have a spout in stock.

Mar 10, 2010 | Gaggia Syncrony Logic 74884 Espresso...

1 Answer

Gaggia Syncrony logic loses water pressure. If left unused for an hour or two it only dispenses half the water it should. After this it's ok until not used for a while. Any ideas?


Yes the machine should not be left on for that long, it only takes a few minutes to heat up. It does not have an auto refill if the boiler is low on water.
If it heats up the water in the boiler for over an hour, it is safe to assume, that the water might at some point turn to steam, when you use it for the first time, it flushes out all the steam, and fills the boiler with water.

Feb 20, 2010 | Gaggia Syncrony Logic 74884 Espresso...

1 Answer

Gaggia syncrony logic not dispensing water. Just drops pods and red light comes on. have cleaned brew unit shower screen and dispenser tube. still have the problem


Lubricate the brew unit with a food safe grease this should help.
The brew unit becomes stiff and fail to load up fully this stops the water being dispensed

Jan 18, 2010 | Gaggia Syncrony Logic 74884 Espresso...

2 Answers

After the coffee is ground and pressed, no water goes through to brew the coffee and dispense it


Sounds like the brew unit is blocked, to be sure try this, use the pre grounds button to brew a coffee, if no water comes out then it is the brew unit, remove unit and look under red o-ring, you will see a shower screen, clean shower and tube that flows to the discharge(top, you will have to remove the 2 screws up there, be careful not to lose the small plastic ball under the spring). Reassemble and try again.

Jan 18, 2010 | Gaggia Syncrony Logic 74884 Espresso...

1 Answer

Gaggia is now about 10 years old. It works uo unti the dispensing point. Then coffee gos all over the floor. When I open the machine the dispenser , left hand side , is full of coffee. Will a new dispenser...


HI
That is a stripped thumbscrew. You need a new one. When it starts to brew, the stripped thumbscrew pushes up and allows the coffee to fill the head and dredge drawer.
The plastic rod that has 2 small hooks on the end and has ribs around the opposite end is your thumbscrew. It holds the filter screen in place. There is suppose to be a small round nut that is molded into the position between the legs with the hooks. If you use the key to tighten the thumbscrew you will pull the nut out and then the thumbscrew will pop out of the brew head. Check the stem of the filter screen. If you have an item that is about 3/8 of an inch long and has a grove in the middle and small bumps on it, that’s the nut. You need a new thumbscrew. Remove the old nut on the stem before putting it in the new thumbscrew. Remember it’s a thumbscrew, so it only needs to be finger tight. The key is for removing only.

Jan 10, 2010 | Gaggia Syncrony Logic 74884 Espresso...

3 Answers

Gaggia Syncrony won't heat up.


I switch the machine on and the green light (number 24) flashes to indicate it is warming up but it never gets there it just keeps flashing for at least half an hour.

Dec 31, 2009 | Gaggia Syncrony Logic 74884 Espresso...

2 Answers

Hi, Our Gaggia machine will not disburse water through coffee dispenser. Sounds like its operating normally till water flow should happen. Then the motor slows down to nothing. Have descaled to no effect....


Try this press the button for ground coffee then when it lights up press the coffee brew button, if water flows normally then the grind on the grinder needs to be adjusted coarser, if no water then the screen on the brew unit is blocked.

Sep 07, 2009 | Gaggia Syncrony Logic 74884 Espresso...

1 Answer

Where to find a dispenser holder for Gaggia Syncrony logic


Need also to find height adjustable coffee dispenser, also need measuring scoop,brush and coffee dispenser with wrench.

Apr 25, 2008 | Gaggia Syncrony Logic 74884 Espresso...

Not finding what you are looking for?
Gaggia Syncrony Logic 74884 Espresso Machine & Coffee Maker Logo

Related Topics:

331 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gaggia Coffee Makers & Espresso Machines Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Gaggia Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...