Question about Washing Machines

1 Answer

Some water comes in it little water then it stops with uud alarm

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

  • Contributor
  • 5 Answers

Turn off and remove both water lines on the back of your wash. Where the hot and cold lines attach to the back of the washer(2 threaded fittings, generally 1 blue and 1 gray). Inside the blue and grey fittings you should find a screen, They are designed to stem the flow of debris from entering in your water lines from your water source. If debris were to pass through to the fill valve it would clog and possibly damage the fill valve

Posted on May 26, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Yamaha 115 4 stroke alarm sounds when boat is in neutral. forward or reverse no alarm. oil is good and water out of the spout.

Which alarm is sounding? Oil or overheating? You need to figure this out first! ... Is the water coming out of the spout high pressure or can you hold your finger over it and stop the flow? If you can stop the flow, you have a bad water pump impeller. If not... you are probably getting good water pressure. If your oil tank is full, the low level sensor is dirty or bad..this will cause the alarm..Fix each of these and repost.

Jun 06, 2017 | Yamaha Boating

1 Answer

My alarm on my liberty sump pump is going off. Its a brand new house a little over year old. What is the problem, because I can still hear water being pumped.

While it still pumping, the unit recognizing the water table being higher than expected. Could happen for a few hours after a serious down-pour. If it's longer, would seek professional assistance to figure out if your pump's output works properly, or you have just too much ground water coming in. Don't wait too long. If it's a unit defect after all, it should still be under warranty, according to manual at libertypumps . It also describes how the water sensor is supposed to be mounted. Make sure it didn't fall off (into the water).

Oct 08, 2013 | Liberty Almp1 Indoor Water Alarm 115v

1 Answer

My Delonghi portable air conditioner stops working all of a sudden and the alarm light comes on.

The alarm light glows when the water collection bucket(s) need to be emptied.

Jul 07, 2011 | Heating & Cooling

3 Answers

My G-Shock doesn't beep every hour, how do i get it to do that?

To make it beep every hour you must first put it on the alarm mode. Then, press the START-STOP button until a little bell shows up at the left. Hope it helps!

Oct 01, 2010 | Casio G-Shock G2600 watch

1 Answer

Machine lets a little water in then stops,this repeats a few times then stop alarm goes off

Hi just read your posting.Just a couple of questions. 1 What is the model number of the machine? 2 When the alarm starts there will be flashing lights.They will be in a row of 8 lights.Starting from left to right which ones are lit,Is it the 2nd and 5th or the 4th and 7th ---etc---?Please reply with additional information and I can help you rectify this fault.

Jul 23, 2010 | Fisher and Paykel Washing Machines

1 Answer

MQ3-45B problem.

have you opened the electrical cover? four screws on top. Is there water inside?

Mine has stopped working also and has water in the elect. box. I'm pretty sure from condensation. The water coming into the pump is really cold and the warm motor is causing condensation which finally builds up and shorts out the capacitor. Although my capacitor looks ok, but the little controller on the circuit board is melted. Would like to try and find a new circuit board, don't know where to look as yet.

Jan 10, 2010 | Grundfos MQ3-45 1 HP Pressure Booster...

1 Answer

Alarm going off and can't stop it

Have you ever heard an alarm go off? Secondly, have you ever heard an alarm COME ON? Which was louder?

What you probably hear is a power failure alarm. Unplug it for a few minutes, then plug it back in and see if it clears itself.

Apr 24, 2017 | Frigidaire Gallery Series GLHS269ZDB 36"...

2 Answers


The door alarm beeps constantly on my GE Prof Arct. The filter light is blinking when it beeps, but I do not have it hooked up to water. Is there anything I can do to stop it?

Aug 22, 2008 | GE J Series 18.2 cu. ft. Top Freezer...

1 Answer

Filter in saeco magic delux

little magnet keeps that red light from coming on.

magnets probably gone bad, need to buy a new water tank. As far as i know saeco does not sell the magnets seperate.

could also be a blockage sending the machine into alarm.

May 08, 2008 | Saeco Magic De Luxe Espresso Machine

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1466 Answers


Level 3 Expert

76164 Answers

Brad Brown

Level 3 Expert

15729 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides