Question about Pride Jazzy 1113 ATS Indoor Power Wheelchair

2 Answers

No power , no lights on controler. Had battery checked and voltage is good . worked a few days ago . brought to home shop , charged seemed to be OK, next morning , no work. Is there a hidden circuit breaker ?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 692 Answers

Check on the utility tray where your charger cord plugs into the rear of the chair it should be on the far left side of the tray near the amp meter Hope this helps

Posted on May 24, 2011

Testimonial: "Thanks for the help, but the problem was the controler buttons not closing the circuit. Thanks"

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 38 Answers

If the chair has been through rain, snow, or anything like that, it will malfunction which then you'll have to call the company and bargain what you can do. If that's not the case, make sure you check all electrical connections and also all controller connections. If everything is where it's suppose to be, then try hitting the circuit breaker switch, which is between the meter and the charger receptacle. After that, turn on the controller. If it still doesn't work, contact the company. They're normally helpful with giving advice on the possible problem. Good luck! :]

Posted on May 24, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 Blazer V6 4x4 Intermittent start problem New battery Alternator? good Start a few times then won't, no sounds/lights Voltage read low Charge battery and it's good for a few days Any suggestions


When the vehicle is running check voltage at the battery . should be 13.1 to 14.1 volts , if not the alternator isn't charging . Doesn't matter if the alternator is new , has to have B+ voltage on the heavier wire connected to back of the alternator . The other wire connected to the alternator comes from the PCM/ECM . Is the Battery symbol light on when vehicle is running ?
The powertrain control module (PCM) or vehicle control module (VCM) turns the generator ON or OFF, by applying voltage to the generator control/monitoring circuit 225 (RED). The regulator in the generator also requests the charge indicator located in the instrument panel cluster (IPC), using the same circuit. When the regulator monitors that either a voltage high or voltage low condition exists with the engine running, a ground path to the PCM/VCM will be provided through the generator control/monitoring circuit 225. The PCM/VCM then sends a serial data message to the IPC requesting the charge indicator to be turned ON. The IPC monitors serial data messages from the PCM/VCM, and turns the charge indicator ON when requested. It mite be best if you take your vehicle to a qualified repair shop , unless you like making parts stores rich , buying unneeded parts .

May 18, 2016 | Cars & Trucks

1 Answer

I have a 2003 ford focus wagon second hand. My battery died out and I thought the alternator was the problem. Brought my car to an alternator repair shop and they said the alternator is still good. I ended...


Lead acid batteries don't like being discharged flat, and it could now be damaged and unable to hold a charge. It does sound as though the voltage regulator part of the alternator is allowing discharge to ground when it should not. You would seem to have a good warranty claim on the battery given they did check the alternator and pronounce it OK.

Nov 04, 2013 | 2003 Ford Focus

1 Answer

I have a tss300 powerchair it wont charge


I brought the TSS300 home put the seat back on the drive portion, reconnected it and nothing works, lights don't come on key button don't work and won't charge, everything is just dead. Checked Battery voltage and it is good. What can I do ?

Mar 10, 2013 | Pride Mobility Pride TSS300 Power Chair -...

1 Answer

The truck stalled a few days ago. It was jumped and ran fine. Yesterday it stalls again, but won't the battery won't hold a charge. It was towed to the shop and they said everything tested fine once they...


sound like might have a prooblem with the charging system. if the altenator is not charging the battery while driving then when the battery voltage gets too low (prob around 10volts) then the computers will shut down, then when jump started it gets some power back, and when the battery is charged will all work fine for a while.
does your model have the voltage gauge in the dash? should be over 12 volts when engine running, 14volts is a good charge rate. and should stay up above 12 all the time, with lights on air condon etc...
and altenators can be funny, work sometimes, and not atother times,

Mar 24, 2011 | 2002 Mitsubishi Montero Sport

1 Answer

Problem w/ razor dirt quad. I replaced the control module, it ran for a few days then died. Bought another control module and it doesn't go at all. I checked the batteries and they are putting out just...


Well this post was done a long time ago, seems like you have a bad battery. you should see 24vdc. The batteries are in parallel so it adds up to 24 volts.If one of them is dead it would only show 12vdc.

Sep 06, 2010 | Razor Dirt Quad Bike

1 Answer

Dash, wipers and door locks didnt work, replaced fuses and it seemed to fix the lproblem, dash lights went out a few days ago and now it doesnt turn over or even grind when i trlyl to start it,


SOUND LIKE DEAD BATTERY OR LOOSE OR CORRODED BATTERY CABLES.HAVE BATTERY TESTED USING A DIGITAL VOLT METER.BATTERY VOLTAGE SHOULD BE 12.5 VOLTS IF NOT HAVE BATTERY CHECKED AND CHARGED.IF BATTERY WAS NO GOOD.HAVE ALTERNATOR CHECKED OUT.TO MAKE SURE IT IS CHARGING BATTERY.TO KEEP FROM LOCKING OUT YOUR RADIO.TURN IT OFF BEFORE DISCONNECTING BATTERY CABLES.

Feb 13, 2010 | 2001 Kia Sportage

1 Answer

97 Chevy Blazer - good battery, good alternator...still dies???


check battery voltage when you turn off car. it should be 12.5 volts.if drops 11.0 volts the battery is got a weak cell in it.i bought a sears die hard battery it last 2 years the battery had a defect .it had a bad cell it short out the battery.check alternator wires for defects.

May 29, 2009 | 1997 Chevrolet Blazer

1 Answer

Two months ago i had problems with my electrical system. The car shut off and the engine smoked. The mechanic told me that he replaced a module and some broke wires. Before I brought the car home I had the...


sounds like alt. wasn't charging/or bat wasn't taking charge. take bat to have tasted. if its ok. suspect the alt. with a good bat. the voltage at terminals when running with lights on should be 12-14.5.

Dec 09, 2008 | 1992 Lexus Ls 400

1 Answer

Several secondary electrical systems not working -- 1998 CLK


They can check the battery and the charging system for starters. Fully charged battery,clean cables. then do a load test on the battery. If it didn't pass the test replace it and check the charging system.
Charging system easy to check , Put voltmeter on battery terminals and monitor vehicle's voltage with and wthout accessories on. should be between 13.5 to 14.5v . Before condemning alternator inspect wiring behind alternator ...if corroded replace then retest.
If voltage is with range then the problem is in the power distribution compartment/ relay, or either is a ground all those items share.

Aug 13, 2008 | 1998 Mercedes-Benz CLK

Not finding what you are looking for?
Pride Jazzy 1113 ATS Indoor Power Wheelchair Logo

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pride Health & Beauty Experts

Robin Hill
Robin Hill

Level 3 Expert

1263 Answers

wcdoc1953
wcdoc1953

Level 2 Expert

278 Answers

Colin Taylor

Level 2 Expert

346 Answers

Are you a Pride Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...