Disassembly of gateway 610XL
take cover off top of base.- pry off
remove two screws that hold speaker unit, it will tilt out, disconnect cables and remove speaker.
two screws on back of base and then take off back cover.remove sheild cover.
disconnect all cables. 4 screws hold power supply in.
rca connector board has little black button holding it on. pry up and then remove board to access connecters behind.
pull all cables out towards you.
remove 6 screws that hold base to back of screen, pull up tape under where cables go thru hole.
remove base from screen.
take out screws on back of screen. carefully pry all around case to seperate.
remove back, and then sheild. there are a few screws that hold it on.
your screen was black, then the two inverter boards could be the
problem. there is one in the upper left corner and one in the lower
left corner. you can by them on internet. match the partnumber, there are 2 diffent ones.
Nov 04, 2008 |
Gateway Media Center 610XL (610XLMDIA) PC...