LOST THREAD.. - Oakley Juliet Sunglasses

Hope this helps

YOU MAY SEE THREAD HANDLER HAVE SOME PROBLEM. THERE MAY BE SOME THREAD TON IN IT

my CG550 is running very slow I need help?

Make sure all the settings are as they should be for threading and try again.

You can manually thread the loopers with a very fine gauge guitar wire or beading thread (looks like fishing line) with a loop on one end to hold the thread.

If you still cannot get the machine threaded, take it to a dealer to see if they have a wire threader instead of the DIY method I explained.

Get a wire threader for the machine from the dealer and store it in a safe place as it is easily lost - I lost mine 2 years ago - they are so thin they disapear!

Here's the Janome instructions!

http://janome.com/index.cfm/LearningCenter/Techniques/General/Winding_A_Bobbin

i need information on threading a 920D brothers serger, on paper so i can take it to my machine to thread

Here is a diagram:

http://www.sewusa.com/Threading_Diagrams/Threading_Pages/Brother_Sewing_Machine_Threading/brother_LS_1217_threading_diagram.htm

how to thread a janome model 372

Place thread spool on the spool pin at back right top of machine. From there, thread through 1) rear thread guide (little hook), 2) front thread guide (front hook), 3) down and up through the thread tension dial from right to left so that thread picks up the thread spring check (the little spring on the left of the tension dial). 4) Through the thread take-up-lever, from right to left (the little lever that goes up and down). 5) Through the thread guard and guides (one on the front, one on the needle arm). 6) Through the needle, front to back. Good luck johntrev800 (at) yahoo.com

Thread the needle last.Thread the lower looper first.
sewman7