Question about Computers & Internet

2 Answers

How do i hook up my linksys wireless-g broadband router wrt54g-someone disconnected it

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,737 Answers

Actually, it's not very difficult, but it looks like you don't have much knowledge. Well, there are four output ethernet ports labelled 1. 2. 3. 4. and one input port labelled Internet. The line from your service provider should be plugged in to the Internet port. You can connect your (if you are connecting using wires) computer via Cat (5 or 6) cable to any of the available 4 ports. I am not confident you'll be able understand without screenshots, so I've attached the manual. Please download it from HERE and follow the instructions in Chapter 4.

Let me know if you need further help.

Good Luck.

Thanks for using FixYa.

Posted on May 20, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,338 Answers

Disconnect the power to each unit (except computer, shut it down). After you connect the modem,router and computer, power up the modem,then the router,then the computer.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response

Thanks, Joe

Hook it up per this diagram:

how do i hook up - joed911_1.png

Posted on May 20, 2011

  • 1 more comment 
  • JDTec
    JDTec May 20, 2011

    the diagram did not show . email me and I will reply with the diagram..

  • JDTec
    JDTec May 20, 2011

    joediaz911@gmail.com

  • JDTec
    JDTec May 20, 2011

    Diagram is near the bottom of this Linksys link______________________________________________________________________

    http://www6.nohold.net/Cisco2/ukp.aspx?p...

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I lost my driver CD for linksys WRT54G broadband wireless router, what should i do? thank you


you can download the driver from the following link:

http://www.nodevice.com/driver/WRT54G/get43729.html

Nov 17, 2010 | Linksys Wireless-G WRT54G Router

2 Answers

Hi I have a linksys wireless-G broadband router but I have no instructions to set it up


go to http://homesupport.cisco.com/en-us/wireless/lbc/WRT54G, click on downloads tab and select a Quick Installation Guide.

Sep 27, 2010 | Linksys Wireless-G Broadband Router

1 Answer

WRT54G keeps disconnecting itself, requires disconnecting/reconnecting power and running setup disk again to reconnect. System info: 12 mb/s cable broadband ISP, Motorola SB5105 cable modem, WRT54G...


Go to Administrative Page on your router at section Setup - Basic and activate: Keep Alive : Redial Period 30 seconds.

After that restart your router

Mar 04, 2010 | Linksys Wireless-G WRT54G Router

2 Answers

Need settings for Huawei HG510 with Linksys wireless WRT54G


You could reset you router to default settings.
On the back of you router, you will find a little hole
using a pen, press that reset button.

Mar 27, 2009 | Linksys Wireless-G WRT54G Router

1 Answer

How can i reset my Linksys Wireless-G2.4GHZ Broadband Router settings


Try to reset the router. This should resolve your problem. That model has a small hole were you must press with some a paper clip for exemple for a few seconds. This will reset the router to its original state.

Nov 07, 2008 | Linksys Wireless-G WRT54G Router

1 Answer

Installation linksys wireless-g router


In order for you to setup the WRt54G to work with your Ibook you nee d to manually configure it since the setup CD for the WRt54G wont run on your MAC computer, In manually configuring the router you need to access the setup page of it and there you can set it up, I will advice you to contact Linksys tech support so one of their tech can walk you through with the process the number 800-3267114 they are open 24/7...

Hope that helps...........

Oct 10, 2008 | Linksys Wireless-G Broadband Router

3 Answers

Can you recommend a router?


I have a Cable modem SBV5222 Surfboard from Motorola and I think my Linksys G router might not be compatible,can you help me with any suggestions as which kind of router will be more ideal to go wireless?

Jul 30, 2008 | Linksys Wireless-G Broadband Router

1 Answer

Useing WRT54G WITH STARBAND


your starband is if im right the cable modem ? connect the modem to the router and then the router to the computer ? then run the linksys easy connect @ www.linksys.com/support

Jul 19, 2008 | Linksys Wireless-G WRT54G Router

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computers & Internet Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

kakima

Level 3 Expert

102366 Answers

David Payne
David Payne

Level 3 Expert

14161 Answers

Are you a Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...