Question about Car Audio & Video

2 Answers

Hi, i'm trying to hook up a pioneer head unit in my buddy's 1992 ford club wagon van. the original reverse wire harness plug was cut off in the dash, so i have nothing to plug my aftermarket harness in to. i dont know which colors are which so i need to know the factory colors of the wires in the van so i can match them to my harness which is EIA colored

Posted by on

  • 1 more comment 
  • Ryan Armour May 20, 2011

    yes, those colors are EIA color codes. i am very familiar with those colors, but the problem is the original factory plug in that was hooked up to the factory wires was cut off so now i'm dealing with trying to wire a new reverse oem harness with EIA colors to the cut off harness which has crazy colors like pink/green, orange/black, blue/wite, yellow/black, green/yellow. so its pretty much become a guessing game. what would help is if i could have the the color diagram for the stereo wires for this particular van- 1992 ford club wagon. ive been looking all over google and everywhere trying to find one. the closest i could get was i found a wiring diagram for 96 and up. i think the constant was like green with yellow stripe and the ignition was yellow with black stripe and ground was easy it was just black i dont remember all the speaker colors but if i could find this dam diagram i'd be good to go haha

  • Ryan Armour May 20, 2011

    I need to know what colors are what in a 92 ford clubwagon van. the factory oem harness was cut off in the dash and now i have to wire a new one so i can plug in the aftermarket stereo. the problem is the new harness has standard EIA colors- red is acc, yellow is constant power black is ground etc. well the stock van wires are totally different im basically in a guessing game and im losing. thanx for the help- Ryan

  • Ryan Armour May 21, 2011

    So the 92 ford probe should have the same wiring as the 92 ford club wagon?

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,555 Answers

1990-92 Ford Probe Stereo Wiring Constant 12V+ Blue/Red Switched 12V+ Blue/White Ground Chassis Illumination Light Green/Black Dimmer n/a Antenna Trigger White Speakers Front Speakers Left Front (+) Blue/Orange Left Front (-) Blue/Black Right Front (+) Blue Right Front (-) Blue/Green Rear Speakers Left Rear (+) Green/Orange Left Rear (-) Green/Red Right Rear (+) Green/Blue Right Rear (-) Green
I hope this is sufficient for you or else kindly let me know if you wan't me to tell you the interconnection with EIA color also.

Posted on May 20, 2011

  • Aruna Singh
    Aruna Singh May 21, 2011

    Yes it should. Since I'm practically not having that vehicle with me thats why you have to check it out and let me know. In case you find difficulty connecting kindly let me know which particular color code you are having trouble with.

×

Ad
  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

99 precent of the time,, in most every car or truck i have installed a system in,, the wiring is pretty much the same,,,, black is ground,,, red is 12v ignition, yellow 12v battery,,. blue will be your remote,,,than your wires like purple,,brown, gray.. they should be matched in color but one will have a black strip,, purple and purple with black strip,,these will be your speaker wires, and u will just have to touch wire to wire to find left and right front and back,,, it pretty easy ,, hope this helps

Posted on May 20, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

Never Cut The Stock Harness.


The best advise I can give and the worst mistake you can make while trying to install a new head unit into a car is DO NOT CUT THE STOCK HARNESS.

New head units come with bare harness with just wire ends, so you may think you need to cut off the harness on the car to wire it in.

This is the worst thing you can do. As a matter of fact, it is a bad Idea to cut any harness for anything in your car as they make wiring harness adapters to fit every thing in your car.

Before you install your head unit, go to Best Buy, or any car audio place, or on the internet and get a harness to suit the install. For instance if you have a pioneer head unit, and a 2007 Honda, you want a pioneer to 07 Honda wiring harness. This will allow your head unit to connect right into the stock wiring harness.

The same can be done for the speakers as well.

on Jan 01, 2010 | Car Audio & Video

1 Answer

No running or dash lights on 97 e350 ford van.replace switch and fuse..fuse blows out after a minute and when you turn lights on engine idle decreases


Most likely a short in the front fender parking lights (look for a rubbing wiring harness) or in the tail lights (damaged wiring harness along frame), if the vehicle is in the north, this is more frequent as ice and snow and mud mess up wiring especially heavy salted areas.

Mar 29, 2014 | 1997 Ford E-350 Econoline Club Wagon...

2 Answers

Pioneer DEH-3300 UB


Apparently, you have no power at the 12 volt battery/memory wire at the radio harness of the vehicle. This wire is white with blue in color.
Also, based upon your description, you have connected the battery/memory wire and the accessory wire of the radio to the 12 volt accessory (switched) wire of the vehicle. This wire is white with red in color.
Check the radio/ stereo fuse of the car. You may have blown the fuse during your installation.
You have no memory at the radio because when you turn off the key, you lose all power to the radio.
Also, I mentioned the wire colors just in case you used an aftermarket radio wiring harness. Make sure that the yellow from the Pioneer unit is going to the battery power source and, the red of the Pioneer is going to the switched power source.

Sep 12, 2012 | Pioneer Car Audio & Video

1 Answer

Pioneer p 4300 in 1994 ford E250 not working. I didn't know I was supposed to disconnect the battery when hooking up the pioneer harness. I was planning on splicing in the pioneer harness so while I...


Have you tested the hot lead going from the car's harness to the radio with a multimeter, to see if you're getting voltage? You may have either popped the fuse in the fuse box, or may have shorted either the car harness or the head unit harness.

Aug 09, 2011 | Pioneer DEH-P4300 CD Player

1 Answer

I have a 2010 XLT Club Wagon E 350. It had reverse aid and no trailer towing package. I installed the ford wiring harness that had the trailer connectors (it replaced the harness from the connector on the...


More than likely your van is just missing the required fuses and relays. In the fuse panel in the engine compartment there should be a 20amp fuse in location F48, a 20amp fuse in location F57, a 15amp fuse in location F58,and a 30amp fuse in location F63. There are also 4 relays required. 2 rectangular 5 pin(Part#F5TZ-14N089-B) and 2 small square 4 pin(Part#5L3Z-14N089-AA). Unfortunately these are not given locations so I will try and give you an idea of where they go. The 1st 4 pin goes above fuse F53 and the 2nd goes above fuse F56. The 1st 5 pin goes above fuse F17 and the 2nd goes above fuse F21. If you have the owners manual these will be easy to find or a diagram may be stamped into the fuse box cover. Also some vehicles come with all the required fuses and relays and instructions in the glove box for adding trailer tow. I'm not sure if an E350 is one though.

Jun 02, 2011 | Ford E-350 Cars & Trucks

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4862 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

The Knight
The Knight

Level 3 Expert

74251 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...