I cannot start my Candy Aqua 100F machine. Flashing light indicates the door isnt locked.

Sounds like Door Lock is defective or it’s a control problem

It could be a bad door lock switch. I had taken my machine apart to clean the boot and accidentally dislodged one of the plugs (there were 3 on the mechanism) on the door lock mechanism. I got the same actions from my machine as you are. Since you probably haven't taken anything apart, a bad switching mechanism can cause the same problems.

F06 - Door lock fault
Issue: Washing machine door cannot be opened or closed/when the door is closed the machine the programme will not start.
Advice: If your washing machine door will not close, please check for any obstructions in the door lock.
OR,
Switch off the device. Disconnect power. Wait about 3 minutes.
Open the door, then close. Reconnect device to the network.
Start device.

Cause: Door lock fails to close / open door lock triac open / closed,
frequency signal fault

Dado

the door lock isnt detected ??

then the door interlock has a problem

the door lock is not operating and will not start this is a saftey feature you will need to replace door lock

The stop light and the spin light flashing are acting as an error code. Have you tried to google what this means? here is a link to candy error codes for that machine...
http://www.ukwhitegoods.co.uk/help/fix-it-yourself/fault-codes/laundry-fault-codes/3319-candy-grando-washing-machine-series-fault-codes.html

hope that helps

The machine cannot lock the door. Sometimes the result of a slightly sticking door interlock mechanism. Open the door and close it hard and firmly (slam it a bit, but don't get silly about it!). A good test to see if this is the problem is to attempt a program with the door swinging open. If the symptoms (flashing key) are the same, then the issue is almost certainly narrowed down to that door lock mechanism.

If this fails, unplug the machine from the main power source and leave it for 20 minutes to allow it to reset its self, then try again.

do u still have power to the machine? try a spin cycle? try a rinse cycle if neither works u have a power supply fault.did u wire the door lock correctley?

reposition the switch.. in the door

first try holding button at door with finger and press start..if same symptom appears...check tab that depresses that switch and if its good try to reposition or replace switch.

hi

We have a whirlpool AWO?D4705 washing machine. The red light is flashing to say clean pump.wee cannot find our manual , can you help please?