An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert who has written 20 answers of more than 400 characters.
An expert who has answered 20 questions.
Re: Denon AVR Reciever
You might have a short somewhere behind the back of your receiver.Maybe a speaker wire sticks out and it is touching the back of the metal panel,or an RCA connection to a wrong input or output. It is common because when you are behind the receiver for so long,carelessness will cause you. A professional A/V troubleshoot expert could pin point certain connection to fix it for you,but in your case,it will be the best to unplug everything first,turn on the receiver by itself and see if there is anymore shut off;if it doesn't shut off after you have nothing that is connect to but only the power cord,i prove my point! Let me know, solutiondoct
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Turn the unit off by main switch (not a standby button). Press and hold "Speakers-A" and "Speakers-B" buttons and turn on main switch. Display blinks. Release the buttons after 3 seconds. Receiver is reseted.
you need to check your speakers connections to make sure nothing is touching and all is connected right and not to have to many spkrs on the channels, also only have the skrs on that you are using, make sure zone 2 / 3 are off and multi volm is turned down
it a control switch and power supply that needs to be replaced they have blown.
get in contact with me so I can help you financially...I can buy your unit for parts.
It will cost more than the unit email@example.com
I read something the other day in the user manual about re-setting the microprocessors if the display doesn't display properly.
Turn the amp off.
Hold down the input mode & analog buttons while turning power on. The whole display should flash on & off at 1 sec intervals, then release the two buttons.
This resets the microprocessors & supposedly fixes display problems.
This means that something is seriously wrong with the unit(blown amp, shorts, opens, etc.) however, you can reset the unit by unplugging the unit, holding the A and B channel buttons on the face of the unit and plugging in the reciever. the display should flash at 1 second intervals. if it doesn't stop flashing on its own then unplug and replug and you should be good to go! good luck.