Dryer got extremley hot and now doesnt turn on

looking for filter for a holly duo trol gas furnace

your thrmostat has been short circuited, replace it immediately and plz dont use the heater before you replace the thermostat of u r machine....its dangerous!!
thx :)

Try turning drum, or remove top from dryer to confirm if belt has gone. When turning drum there should be some resistance as the belt fits around the drum

when a dryer does'ny blow hot air,it's normally either the element or the stats on the element.

You probably need a new heating element it is located behind the drum take the back panel off and turn the dryer on to see if it teurns red if not it is burnt out.

you probably have one of the wires not connected correctly. or you could have bad themostat.

If you can turn it on and have the door open, hold the door switch in and see if you have a glow from the heating element. If not, your element is broken. That is if it is an electric dryer. If it is a gas dryer you need to check the pilot light or the thermo sensor.

We had a similar problem with our dryer just last month. It would spin and turn on, but no heat. It turned out not to be anything wrong with the heating element--it was a tiny electrical part that had malfunctioned.

Anyway, I would recommend calling in a professional if you've already cleaned your dryer and still can't get it to work. That could save you a lot of time and money in the end.

Violet Campbell ' http://www.ayersappliancerepair.net/appliance-repair-services/

no but are you sure your replacement parts are correct the cycle stat is usally running about 140 - 160 temps did you switch the high one and the cycling wires or parts?

It sounds like the gas supply is not giving you any gas, as both have the exact same symptoms. You can see the glow coil getting red hot, then the safety shuts off after a it gets no gas. If you feel confident, shut off the valve in back coming from the wall, unscrew the line where it connects to the dryer. Turn the valve back on slowly, there should be gas pressure blow out of the line.