Hello, My HP deskjet 5650 prints out error code: 905D0303. What does it mean? Thank you, PW

PLEASE SEE this 2011 FIXYA Solution:

Hello My HP deskjet 5650 prints out error code 905D0303 What does it mean...

Hope it works for you too!
Anthony

Hello Sgaetjens,

The tear drop shape LED is called the print catridge LED indicator. If you do see this light flashing it means that there is an issue with one or both of the cartridges. This issue can occur for the following reasons:

• One or both cartridges might be incompatible with the product.
• One or both cartridges might be improperly inserted.
• The borderless printing settings require adjustments.

For the first,two I suggest that you verify that it is indeed HP original cartridge and not just replacement ones that you can purchase anywhere. Remove and reseat the ink cartridges carefully. With regards to borderless printing, go to Control Panel and then Printers and open up your HP Printer and then check the properties and defaults. Normally it is under Printing Shortcuts where you could find Borderless Printing.

Hi, When you have installed the ink cartridges make sure connections are clean that means finger prints as well. Clean with isopropil alcohol not rubbing alcohol. Next, check printer properties that software is working properly. If all is OK. Cartridge maybe clogged or defective (replace).

Just check your printing property and choose color print and apply the settings and then ok.

Good Luck

Print failure is a very common issue faced by users while printing a document. There could be many issues if you are unable to print from HP printer. But you don't need to worry, we are here to help you out.http://www.hptechsupportnumber.com/ HP Tech Support Phone Number 1 877 645 7494 HP Helpline

Hi dear; When you put in the new cartridge ,did you removed the plastic seal(tape)?

why dont u check HP deskjet website for printer driver update? may be its avaible there.

well..assuming that the text is the same on all, this might be a settings issue, with the print spooler. That's in the set up of the printer, under properties..look into that, and perhaps you'll want to spool the whole job, instead of printing immediately?

print spooler memory is finite, so the longer jobs will take longer.

Blicking lights, not printing and not working

This "plastic strip" is called the "carriage encoder strip". This strip dictates the timing of the carriage assembly. If the end slots aren't broken, you can re-attach it. Otherwise, you'll need to replace it. They are about $10.