Question about Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

1 Answer

How can I get a tech sheet for this?

Tried looking in from back bottom drawer but no paper. Top drawer has no power and will not open using methods mentioned.

Posted by on

  • wabbada Sep 03, 2008

    Hi Mt, 


    seems as though a cocroach had gotten inbetween the heater plate and burnt it out.  whole thing had to be replaced. apparently it is a common problem with these types of dishwashing machines in the tropics. I have put down some roch bait under the bottom draw.


    hpe this helps.


    thanks again.


    Wabbada

  • Gary Davd
    Gary Davd May 11, 2010

    forward 2 where? post an email pl

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 770 Answers

Still need your email to send you the service manual

Posted on Sep 03, 2008

  • Judy Edmisten
    Judy Edmisten Apr 18, 2015

    Gary David I need one also! There was no tech sheet anywhere to be found. jjjedmisten@gmail.com

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Top drawer can not be open


If this is a double drawer dishwasher and bottom drawing is functional but top drawer won't open means the controller on top drawer is faulty or power circuit is locked. If turning the mains power off and back on makes no difference then controller could be the problem. One way to test is to take the controller from bottom drawer and replace that in the top drawer. This requires a lot of patience and experience with electronic stuff. If you are not brave enough to test then call the technician. The controller is about $200 to buy. Make sure the mains power socket is taken out before working on the dishwasher internals.

FISHER PAYKEL DISHWASHER DD603 Parts

Feb 10, 2014 | Fisher and Paykel Dishwashers

1 Answer

I have a small piece of plastic stuck in the drain hose of my fisher paykel top dish washer drawer. I have tried cable wire but it does not budge after about 3 inches. Is there a way to remove the bottom...


There are two pieces of drain house in a double drawer FP dishwasher. The one from top drawer, the one from bottom drawer which then merge into a U adapter before hoing as a single hose into the kitchen sink.
I don't think anything can be achieved by taking the bottom drawer out. If the obstruction is in the top drawer drain hose, you will have to take that out and turn it over and disengage the hose from the bottom of the sump. Your best bet is to refer to this install guide on removing the drawers. Refer page 7 step 2.
Fisher Paykel DishDrawer Installation Instructions ManualsOnline com
Use reverse method to put it back in. Make sure you keep a stool nearby to hold the drawer in place and not let it fall on the floor. The cables and hoses are very tight and need care when handling.

Jan 09, 2014 | Fisher and Paykel 23 in. DD-603SS Built-in...

1 Answer

Fisher and paykel drawer won't open


You can try to reset by unpluging if you have not already. The problem seems as if its the bot actuators even if it was a flood issue you could still pull open the drawers . Now i am pulling this from memory of the few i have serviced in the field so forgive if i am wrong . try holding the start and cancel button at the same time for a few seconds and this will get you into *** mode. then hit the start button this should start a fast cycle. If you can get the bottom drawer open you can get to the tech sheet in the back and trouble shoot from there. good luck

Feb 16, 2013 | Fisher and Paykel Dishwashers

1 Answer

Top drawer on F&P dish drawer stuck on cycle & continuously beeping


You could isolate the top drawer by taking the controller power cable out. DIsconnect mains power to dishwasher, open top drawer and remove front cover carefull after removing 2 plastic pins on each side with plier. Controller box is on left top side, remove bottom connector and cover with insulation tape. Put things back and turn power back on.

But if you want to find the fault with top drawer then that is very trick if there is no fault code on panel except beeping First clean the top panel inside door with a clean damp cloth. If this does not change the situation, then it is very likely the controller is detecting some faulty sensor - and will need to find one by one. Are you ready for it?

Dec 17, 2012 | Fisher and Paykel 23 in. DD-603SS Built-in...

1 Answer

F1 code appeared during wash cycle..


The Ever- So- Helpful Diagnostics Mode -----
Getting into the Diagnostics Mode:
Press the LOCK and START / PAUSE buttons simultaneously and hold for 5 seconds.
The unit will beep once
Press the POWER button once, and you are now in diagnostics mode.
Pressing the START / PAUSE button sequentially advances the machine through the various functions you will want to test.
Start and stop each function by pressing the LOCK button.
A strong word or caution: DO NOT ENERGISE THE HEATER PLATE function (ER) without water in the tub or the heater will burn out.
The tech sheet containing all fault codes, test values, and a schematic is located behind the lower drawer at the back wall.
Exit diagnostics by pressing power off.

Q: F1 ERROR. The unit is beeping, both drawers are flashing F1 and won't stop running.
A: Your appliance has experienced the ubiquitous F1 flood error. The only way to stop the beeping is to remove power. Your course of action depends on the next step. You need to look BEHIND the lower unit drawer. Remove power, then open the lower drawer all the way, and press those plastic tabs (down at the sides, along the bottom and just below the round buttons)- inwards. Now slide the drawer out a couple inches more. You can now see behind the drawer.
Is there water in the catch pan? If no, the Mains Filter Board beneath that plastic cover in the back is bad. It thinks it's flooded while in fact it is not. Replace it. (PN 525959P) It is also remotely possible that one of the wiring harness is faulty.
If there IS water back there, you need to find where it's coming from. Usually, the fill (PN 526836) and drain hoses (PN 527137) are NOT at fault. Go into Diagnostics Mode, and operate the water fill valve (FV), and look for leaks at the valve and along the fill hose as the tub fills.
(You'll want to remove that large plastic cover in the back to see the valves and hoses coming from them. Lift the drawer off its rails and set it off to the left if there's space for it. Upper drawer, set it on top of the bottom drawer).
Operate the drain pump (P2) and look for leaks in the drain line. If no water is seen leaking from those sources, go on to the Lid Motors and the Link Supports.
First inspect the link support (that white plastic rod that spans the tub service lines). They typically snap in two at the mid span point. If it's snapped, there's your problem. Replace it with the updated link support. (PN 528437) Also run the Lid Motors (LD). As they transition up and down, do they respond strongly, or do they sound weak and labored? If the motors are in a white plastic case, you have the old motors and they will need replacing soon anyway. When they grow weak their ability to pull the seal down strongly is diminished (PN's 528112 Top, and 528113 Bottom)
Should you get an F1 error code on the TOP UNIT ONLY, it means that the LOWER UNIT has experienced some failure in the Water Heating Circuit. You will need to test those components to detect what has failed. Get out the trusty schematic and your multimeter!

Feb 26, 2011 | Fisher and Paykel Dishwashers

1 Answer

Is there a reset button on the dishwasher for the Fisher Paykel DD 605. I washed a top and bottom load, nothing unusual about the loads. The dishwasher just stoped and there is no power on either of the...


If there is no power on both the drawers then 2 things
1. the circuit breaker on the mains power supply feeding the dishwasher has tripped
2. the power board that feeds the drawers is faulty. This is located at the base under the bottom drawer.
The drawers won't open because the power has failed mid cycle and the drawer seal actuator motors are locked in down position.
You can force open the drawers but this could require some mechanical adjustments to the actuator yokes if the two sides are out of alignment when power is restored. In any case you will have to force open the bottom drawer to get access to the power board. The part looks like this but may not be the one specific to your model. You will have to contact a parts dealer local to your area.

The only reset function available is to turn the mains power off and back on.

Hope this helps. Please rate the solution if useful otherwise post a comment.

Nov 25, 2010 | Fisher and Paykel 23 in. DD-603SS Built-in...

1 Answer

Dishwasher won't open top drawer or turn on--


Wonder if you tried to turn the power off at the mains and back on. If that does not release the drawer then most likely the lid seal has locked up.

I am assuming the bottom drawer is operational.
Turn the power to dishwasher off and take the bottom drawer out from its housing carefully without tugging the hoses etc at the back. This will expose the power module at the base. This supplies the power to the lid seal actuator motors on both drawers. Disconnect the leads going to top drawer and turn power back on. This should free up the lid seal - might need a little pull to get drawer to open. Connect everything back in (disconnect power first) and see if it works.

If this is unlclear then drop a comment otherwise rate the solution to help fixya help you better in future.

Oct 24, 2010 | Fisher and Paykel 23 in. DD-603 Built-in...

2 Answers

Top dishwasher drawer will not close


As long as there is no plates or anything stopping it from closeing i will then say that there are 2 side rails that the draw glides in & out on,get down on the floor & check up underneath the draw for smooth gliding operation.also is it possible that a fork or peice of cutlery has gotten over the top & fallen down jambing the draw from closing.

May 29, 2010 | Fisher DD603B / DD603W / DD603H Dishwasher

1 Answer

Hi My F&P dishdrawer flooded. Dried it all out etc, the top drawer doesn't complete the cycle and it beeps continually even when it's not running. I am wondering if I can reset the drawer using the...


Not sure if you tried turning the power off at the main switch. Lock icon can gone away if you press the necessary keys as shown in the user guide. Also the sequence of keys to press for getting factory defaults of different options is also in the user guide. See the long sheets on page 19

Nov 05, 2009 | Fisher and Paykel 23 in. DD-603SS Built-in...

2 Answers

Fisher & Paykel Dishwasher leaked


From what you describe, drain water from the top drawer is getting into the bottom drawer or waste water from the disposer is backing up into the bottom drawer.

1. Each drawer has its own drain hose. Each hose should terminate at the drain point with a 'Y' adapter.
2. Inspect the drain point (under the sink where the drain pipes are) to make sure this 'Y' adapter is present. (you should see two drain hoses from the DW). If not present, then the DW drain lines are not installed properly. (Someone took a shortcut and installed the 'Y' adapter behind the DW)
3. If terminated properly, make sure the drain hoses extend upward as they leave the drain point.

It is important the drain lines are connected properly to ensure proper drainage from the DW. Consult the installation manual for complete details.

Jun 08, 2008 | Fisher DD603B / DD603W / DD603H Dishwasher

Not finding what you are looking for?
Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fisher and Paykel Dishwashers Experts

Gere knutson

Level 3 Expert

842 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Blake

Level 2 Expert

136 Answers

Are you a Fisher and Paykel Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...