At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
To use your system from a remote telephone, you must first enter a 3-digit remote operation security code. The security code label is located on the bottom of the system.
1. Dial your phone number.
2. When your outgoing message is playing, enter your remote operation security code. Bd appears on the display to indicate the system is in remote mode.
If there are no new messages, you hear three beeps. These are the remote codes available to you:
2 # Play all messages. 2 5 Play new messages. 3 # Delete all old messages. 7 # Record new outgoing message. 7 # Stop recording outgoing message. 8 # Record memo. 8 # Stop recording memo. 9 # Turn system off/on. 0 # Monitor the room..
The "recording outgoing messages" section is the first thing on the second page of the manual at
http://www.radioshack.com/graphics/uc/rsk/Support/ProductManuals/4303829_PM_EN.pdf
The "recording outgoing messages" is the first thing on the second page of the manual at
http://www.radioshack.com/graphics/uc/rsk/Support/ProductManuals/4303829_PM_EN.pdf
The "recording outgoing messages" section is the first thing on the second page of the manual at
http://www.radioshack.com/graphics/uc/rsk/Support/ProductManuals/4303829_PM_EN.pdf
- Press and hold the ANNC/DAY/<< button.
- While you're holding it down, say your outgoing message.
- Let go of the ANNC/DAY/<< button to end the recording when you're done.
Your message can be up to 1 minute long.
There should be a greeting,greet,record,or rec button on the front.Press it and hold it down.It will prompt you what to do.
Please write back if that does not work.Good luck!
Well, your machine might be broken, or you haven't set the little switch on the unit to ANS.The switch is on the side of the machine where the cables come out.But here are the instructions from the manual:
Recording Outgoing Messages:
Your answering machine has a built-in outgoing message, "Hello, please leave a message after the tone."You can use this message or record your own.
1. Hold the ANNC/DAY/<<, and speak clearly into the microphone, no more than 10 inches away.
2. Release the ANNC/DAY/<< when you finish.Your answering machine beeps and automatically plays back your recorded message.
*Your outgoing message must be between one and 60 seconds.
*If you record your won message but wish to revert to the pre-recorded message, press DELETE during playback of your outgoing message.
To Record Outgoing Message on
Radio Shack’s Answering Machine [Model 43-3829]:
Press and Hold the ANNC/DAY/<<
button.You’ll hear a beep; continue to
hold down the ANNC/DAY/<<
button and record your message.When
recording of your [outgoing] message is complete, release the ANNC/DAY/<< button.Your message will automatically play back for
you.
Please let me know if you have additional questions. Thanks!
×