Question about Kenwood Car Speakers & Subwoofers

1 Answer

How to huck up my kenwood amp send diagram please

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

Hook it to what, what speakers what type of kenwood amp...

Posted on Aug 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 3 Kenwood 12'inch subwoofers need to know how to wire them up to a Kenwood KAC-9105D


Follow the link and use the first diagram which illustrates wiring the subs to 2.66 ohms http://www.the12volt.com/caraudio/woofer_configurations.asp~Q~3~I~42

Remember that that amp is one ohm stable so you will not be getting the most out of that amp with that subs set up. The subs will only see 650 to 850 watts total...so each sub will only see about 215 - 275 watts a piece. Find out what the RMS wattage of your subs are each an determine if the wattage I mentioned above meets those requirements.

Sep 27, 2012 | Kenwood 12" 4-Ohm Single-Voice-Coil...

1 Answer

I need assistance with a new Kenwood stereo DDX4038BT The Av jacks at the rear do they go to the amp and then from the amp to the speakers The amp i have is a ZX400.1


Yes, they should be labeled for each speaker. Nice radio, please install the fuse (on the power cable under the hood) LAST as to not accidently damage anything.

Aug 18, 2011 | Kenwood Car Speakers & Subwoofers

1 Answer

Trying to find a wiring diagram to install my kenwood kdc-mp342u into my 2001 grand am. any ideas?


Please let me know if you have any questions, and thanks for using FixYa.

2001 Pontiac Grand Am Car Audio Wiring Diagram kenwood kdc-mp342u
Car Radio Battery Constant 12v+ Wire: Orange yellow
Car Radio Accessory Switched 12v+ Wire: none
Run a wire to the fusebox for switched power. red
a 14 gauge wire will do--use a 15 amp fuse
Car Radio Ground Wire: Black/White black
Car Radio Illumination Wire: Gray (tape this wire off) none
Car Stereo Dimmer Wire: Brown (tape this wire off) none
Car Stereo Amp Trigger Wire: Pink blue
Left Front Speaker Positive Wire (+): Tan white
Left Front Speaker Negative Wire (-): Gray white/black
Right Front Speaker Positive Wire (+): Light Green gray
Right Front Speaker Negative Wire (-): Dark Green gray/black
Left Rear Speaker Positive Wire (+): Brown green
Left Rear Speaker Negative Wire (-): Yellow green/black
Right Rear Speaker Positive Wire (+): Dark Blue purple
Right Rear Speaker Negative Wire (-): Light Blue purple/black

Amplifier Mounted behind trim in the left side of the trunk.

May 19, 2011 | Kenwood Car Speakers & Subwoofers

1 Answer

Hi there. I have an old KAC-9020 amp, but it is in very good condition and I wouldn't like to see it go to waste. However, the input for the amp is an 8 pin DIN cable. I could custom wire an adapter if I...


Julian,

I found the owner's manual on the Kenwood website. Please visit the link below:
http://www.kenwoodusa.com/UserFiles/File/Global/Consumer/Manuals/kac9020.pdf

You'll notice that the plug in the diagram is plugged to receiver/tuner/car stereo. Apparently it's a common plug/setup for the Kenwood stereos that have this type of output plug. You would just need to find any Kenwood car stereo that has this output to get the wiring of the plug if you wish to use this amp with a different car stereo. (Or just get a Kenwood car stereo that has this type of output). Good Luck.

Oct 04, 2010 | Car Speakers & Subwoofers

1 Answer

I please need a kenwood kvt 516 wiring diagram to hook up my stereo i dont know what each color is. like left fron speaker etc. please help


battery yellow
accessory red
ground black
power antenna blue
amp turn blue/white
illumination orange
dimmer orange/white
RF + gray
RF - gray/black
LF + white
LF - white/black
RR + violet
RR - violet/black
LR + green
LR - green/black

Sep 27, 2010 | Kenwood Car Speakers & Subwoofers

1 Answer

Subs not programmed into dash...?


It sounds like the input gain on the amplifier needs to be adjusted.

OR if your certain this hasn't changed see if both of your RCA cords (Left and right) are working. I had a similar issue when the mono block AMP was only sending signal from the left channel to the amp which in turn was dropping the input load in half. Its all about isolation.

Simple way to test this is to adjust the L/R balance of your deck all the way left or right and see if the amount of bass changes. If you balance all the way left and you lose your base completely then you know your amp isn't getting signal from the left channel thus if you move it all the way to the right and the bass disappears then the problem is with the right channel.

Jul 05, 2009 | Kenwood 12" 4-Ohm Single-Voice-Coil...

1 Answer

Just stopped working


please check if the supply is still present in your amp using a multimeter. if you dont have a multimeter, check the fuse that supply the amp. a broken fuse will not turn the amp. let us know.

Apr 15, 2009 | Kenwood Car Speakers & Subwoofers

1 Answer

I have a Kenwood KVT-911DVD in my tahoe. I heard a pop coming from the back of my truck, i have an amp under my back sit. i thought i blew my amp, as luck has it, my transmission went a couple of days...


Do any of the lights on it come on. Have you tried to take it out and connect the red and yellow wire to the battery and the black to the truck frame? This to see of any of the lights come on. Did you try to press the reset button? If you press the button and nothing happens then you may have to send it back to Kenwood for them to reset it.

May 20, 2008 | Kenwood Car Speakers & Subwoofers

1 Answer

Kenwood GE-3i


1 wire might be a remote turn on 4 the lost amp. connect a light tester to the ground wire turn on and off the pre amp and see if the light goes on and off 1 might also be a floating ground wire .

Oct 30, 2007 | Kenwood KSC-WA100 Car Subwoofer

Not finding what you are looking for?
Car Speakers & Subwoofers Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenwood Car Speakers & Subwoofers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Larry Spears
Larry Spears

Level 3 Expert

625 Answers

Are you a Kenwood Car Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...