My zenith xbv343 dvd vcr combo has a problem when i put on a dvd it says progressive scan mode i cant see nothin else

Yes you will need component cable and you can attach your xbox to the front left of this combo. You will have to select the correct auxillary input once the xbox is connected so you are able to view on your tv.

1) Remove any DVD that may be inside
2) Press AND Hold Stop Button (on front of Player) for 5 or more seconds
3) All Done - This will have reset player back to Interlaced Mode and you can now see your DVD!

1) Remove and DVD that may be inside
2) Press & Hold "Stop" Button for a little over 5 seconds
3) Solved! DVD Player has reverted to Interlaced mode - You can now see your video!

Have you looked for a Rio Sonic Blue HT2030 manual (it's the same machine)?

Do this:

1) Remove any DVD that may be inside
2) Press & Hold "Stop" Button for a little over 5 seconds
3) Solved! DVD Player has reverted to Interlaced mode - You can now see your video!

Hi jromero
To answer your question;
Make sure there are no disk in the dvd then using the remote press and hold the stop button for more than five seconds.
This will reset the unit to interlaced.
Hope this help Cheers

try this first turn on the dvd now check on the disc tray there is no disc on it now push the stop button for ten seconds good luck

mi zenith xbv342 solo queda la pantalla azul y dice progressive scan mode como salgo de hay

I have the Zenith XBV410 (combo dvd/vcr). I cleaned the lens using the Maxell Lens cleaner kit but nothing happened. Then I ran the Progressive Scan Mode and that seemed to do the trick. Word of caution: Progressive Scam Mode is difficult to turn off so would recommend you remove dvd from player, then press and hold the stop button for a min of 5 seconds up until whatever it takes to disablel PSM (Progressive Scan Mode)

If you set progressive scant On by accident,you must reset the unit. Remove any disc from the unit and close the disc tray. See that "disc" is displayed on the display window. Now press STOP and hold it for more than 5 seconds before releasing it. The video output will be restored to the standard setting and picture will once again be visible on a conventional analog TV or monitor.