Heard a pop sound and projector will not power up

Sounds to me like a blade has come adrift from one of the cooling fans in the unit, throwing the fan out of balance (The pop you heard will have been from the pice of plastic being ejected from the fan). Unless you are experienced in electronic servicing, I would not advise opening the unit to identify which fan - you'll almost certainly have to take it to an authorised repairer anyway since these fans are usually highly customised units

Sounds like something in the power supply blew. Transistor or diode most likely.

Lamp is burnt
Take lamp out and You will see problem, lamp made pop

Your projector is DLP technology. It employs a "color wheel" to provide colors other than blank/white. That "pop" you heard unfortunately may have been a malfunction of the color wheel mechanism, probably the motor. (It runs at very high RPM)

Sounds like you may have to find a shop to service your projector.

Please check the Lamp cover .posibilty not fitted properly

Mahesh
M.R.Corporation
[email protected]

Check out the electrolytic capacitors on your Low voltage power supply board...they over heat, expand and pop...very easy to see...blown caps...

Art

Sounds like a blown capacitor...they age...leak..and bulge..
and then blow out...
Check (visually) all the capacitors on your power supply board...
if they are fat, bulging or leaking...they should be replaced.

Something between 150-200$. In my opinion it won't worth it. Go and get yourself a brand new one...

Souds like a Dlp projector and the wheel inside broke is what it souds like what happend, I would have this serviced.



Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

check all the fans, if still working. if the problem occur get assist to the nearest technician im sure your lamp balasst was deffective.