Question about Frigidaire ATF6000ES Front Load Washer

2 Answers

FRIGIDAIRE FRONT LOAD WASHER

My washer will not start. Wash, rinse final spin lights are on including other light from setting but door lock will not work.

Posted by on

  • 3 more comments 
  • coachftj Aug 12, 2008

    My wash act as if it wants to start - it goes thru all of the motion, locking the door and all the lights come on - the timer begins the count down for the first minute and then it beeps and a error pops up on the LED - the code looks like " ddo " I did find a small magnet under the detergent dispenser, it had attached itself to the top of the washer door. Any help would be appreciated.

  • emills2007 Aug 16, 2008

    did the the advice, e41 comes up

  • Anonymous Mar 16, 2014

    i have a frigidaire ftf2140fs1 that will wash and do the first spin cycle do the rinse cycle but not do the final spin cycle

  • Anonymous Mar 16, 2014

    washer has power to the control panel but won't run. Only locks the door but won't wash,spin or pump

  • Anonymous Mar 16, 2014

    e41 code comes up. washer lights up, door locks but won't wash, spin

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I too had the same problem, I closed the soap tray and a magnet popped out and got stuck to the door. Same problem with it acting like it was going to start and then beeped. This is where the magnet goes, just stick it back in, its held in with pressure (barely) :)

I took the whole control panel off to locate the magnetic reed switch, then just reverse engineered where the magnet is supposed to go on the soap drawer.

FRIGIDAIRE FRONT LOAD WASHER - 3b854ea.jpg

Posted on Sep 26, 2008

  • reinigrauer Sep 26, 2008

    If you still have problems with the washer not starting, take off the top panel (2 screws in the back of the washer, slide the top panel back and lift), take out the soap tray (pull it out, press the piece of plastic down that says push and then pull the tray all the way out), take off the control panel (2 screws on top, 2 screws inside soap tray hole) and find the magnetic switch. It is black with 2 black wires and it is situated right next to the soap tray hole. Cut the wires somewhere in the middle (in case you want to reattach the sensor later). On the 2 pieces of wire still attached to the circuit board, strip the ends off and wrap them together. Use some electrical tape to insulate them from touching anything.

    This will bypass (short) the sensor, telling the washer that the soap tray is always closed. The only problem with this is that if you try to open the soap tray while its filling, you might get wet. Just put the soap in first, turn it on, and don't open the soap tray while its in cycle :)


×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 725 Answers

Press cancel. (turns off washer)
press start/pause (wake up)
hold cancel and start/pause 10sec

last error code will come up.

E47 door lock error

check wires connections to the door lock..

replace door lock..

hope it helps

Posted on Aug 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to Troubleshoot a Frigidaire Front Load Washer That Doesn't Spin Read more: How to Troubleshoot a Frigidaire Front Load Washer That Doesn't Spin | eHow.com http://www.ehow.com/how_6496482


Hello - Does the unit make a humming noise? If so, either the drainage hose/pump is clogged and needs to be cleaned, or you have another issue with the door lock assembly or the timer and control board not communicating correctly. Contact a professional to move forward accurately.

Oct 21, 2012 | Frigidaire Affinity ATF7000E Front Load...

1 Answer

Frigidaire Front Load Washer wont start!


sounds like you have a very unhappy control panel..unplug it, wait 5 min..and then plug it back in..if it does not reset, then you may want a repair job, no?

Apr 30, 2008 | Frigidaire ATF6000ES Front Load Washer

1 Answer

My frigidaire front load washer will not start. anytime I push a button on the front panel the "LOL" sign flashes. on the front of the washer panel d wash rinse final spin control lights are...


Is the message "LOL" or "LOC"? I suspect the child lock "LOC" has been activated. To toggle this off, press and hold Options and Select for 10+ seconds. This feature prevents someone from accidently starting or changing a cycle selection.

There is a small padlock icon in the middle of lines linking the two buttons that let you toggle the child lock on and off.

There are two Frigidaire washers with the model ATF6000ES (the S is followed by a 0 or a 1). The manuals for both are available here: http://www.frigidaire.com/manuals?model=ATF6000ES . The child lock feature is described in the Operating Instructions. For the ATF6000ES0, the direct link to the appropriate manual is http://manuals.frigidaire.com/prodinfo_pdf/Webster/134604400.pdf . See page 2 under Washer Features.

I hope this helps.

Cindy Wells

Sep 21, 2011 | Frigidaire ATF6000ES Front Load Washer

3 Answers

Will not drain and spin keep beeping with error E20


  1. Remove the 2 screws on the bottom and the front access panel comes off.
  2. Pump is on the right, remove hoses from it, remove pump from machine and remove whatever is in the pump.
Try holding the start/pause and cancel key together for 3 seconds. The door lock, wash, rinse and final spin LEDs should light. Any error codes should be displayed when holding those keys.

Feb 27, 2011 | Frigidaire ATF6000ES Front Load Washer

1 Answer

Trouble code e20


Water not draining fast enough. Try holding the Start/Pause and Cancel key together for 3 seconds. The Door Lock, Wash, Rinse and Final Spin LED’s should light. Any error codes should be displayed when pressing the Start/Pause and Cancel keys.

Remove the bottom front panel. This can be done from the rear of the machine by unscrewing the 2 securing screws. The pump sits on the right side. Disconnect the hoses and clean them. Make sure to clean the pump impeller out as well.

Oct 12, 2009 | Frigidaire Affinity ATF7000E Front Load...

1 Answer

Atf7000ep code e20


E20 is a general error code to get to the real problem try this..
Reading Error Codes 1. Wake the washer by pressing any button. 2. Wait 5 seconds. 3. Press and hold the START/PAUSE and CANCEL buttons simultaneously. As long as the buttons are held, the failure code will appear in the display as an “E” followed by two numbers, a number and a letter or two letters. The control will beep and the Door Lock, Wash, Rinse, and Final Spin indicator lights will flash. let me know what code come up... hope it helps

Jun 28, 2009 | Frigidaire ATF6000ES Front Load Washer

1 Answer

Frond load washer Frigidare ES1


press cancel. (turns off washer)
press start/pause (wake up)
hold cancel and start/pause 10sec

last error code will come up.

E47 you need to replace door lock..

hope it helps

Aug 11, 2008 | Frigidaire ATF6000ES Front Load Washer

1 Answer

E21 error code


There is a E21. Water not draining fast enough. Try holding the start/pause and cancel key together for 3 seconds. The door lock, wash, rinse and final spin leds should light. Any error codes should be displayed when holding those keys.
PLEASE RATE THIS !

Jun 07, 2008 | Frigidaire ATF6000ES Front Load Washer

1 Answer

E-43 still after a new control board


Try holding the start/pause and cancel key together for 3 seconds. The door lock, wash, rinse and final spin lights should light. Any error codes should be displayed when holding those keys.

May 31, 2008 | Frigidaire ATF6000ES Front Load Washer

Not finding what you are looking for?
Frigidaire ATF6000ES Front Load Washer Logo

865 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Washing Machines Experts

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Are you a Frigidaire Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...