My polisher has lost power and i know its the chord because when i push it back up it works for a second and shuts off again. I am wondering if there is something i can do to fix this problem or do I have to take it into a Makita store to get the chord replaced??

unplug the power chord then push and hold power button to drain all residual power. disconnect hard drive power supply for ten seconds, then reconnect. plug tower back in and power up again.

check your rgb chord found at the back of your monitor, i think it is color blue chord that connects through cpu and monitor..push it tight and it will display again..

i hope it can help you

Try the following:

1. Unplug the power cord from the laptop.
2. Remove the battery.
3. Press and hold the power button for 10 seconds.
4. Re-insert the battery.
5. Plug in the power cord.
6. Try turning on the computer.

try to do a power drain.... unplug the power chord... then remove the battery.... while the battery is out... press and hold the power button for 30 seconds.... then put the battery back in and then the power chord.... then try booting it up.... if it works well and good.... if it does not and u see all the lights but not anything on the screen, try with an external monitor just to check if its an issue with the lcd screen.... if its working on a different monitor, u know what to do... take it to a service center....

again if nothing works... dont wait.. take it to a service center

Disconnect the power chord from the back of the printer. Wait for 40 seconds and connect it back and check if it is warming up or not. If not the press power key for few seconds and see if it turns on or not.

If not then check if the adapter is getting warm or not after it is connected to wall outlet.
If adapter is warming up then try another power chord and check..

If both power supply are getting warmer then problem is with printer hardware and if printer works with another power chord then replace the damaged power chord

If its Sony KDF-E55A20 tv then replace lamp as symptom shows lamp is near to end of its working life span and causing that problem.
Let me know if you need further help.

Well lets hope nothing fried, What i would recommend to try is to unplug the power chord from the back of the computer and hold in the power button for about 30 Seconds to remove all the power from the board. Then plug the power chord back in and hit the power button and see if the computer starts. Let me know if this works for you. Thanks

It is a lose connection symptom when you wiggling the chord it will be fine it is a cold solder its needs to resolder the connection base so it become firm and works normal again.

Hope it may helps you;

Regards:
VOTIT

Hi..

Since your computer is working but no display at all. Hope this steps would be helpful in your problem.


1. Turn on your computer, If the problem works again and no display.

2.Turn off your computer by pressing long your power botton until the fan stops properly.

3. Unplug you computer 220volts power chord at the back of your computer.

4. Reconnect again the 220volts power chord after 1 minute.

by. [email protected]

I was having the exact same problem with my sony handycam. I actually came across this website looking for the answer and noticed many people having the same problem but there was no solution to it.

I just happened to go to the sony website and decided to watch the tutorial on setting the camera back to the factory settings. It actually fixed the problem! I don't know if this will work for everyone or even how long it will work, but I figured it was worth a try. Good luck!