Question about Projection Televisions

1 Answer

Hello i need a new 52 inch screen to replace the one that is currently on my phillips t.v. is it possible to just buy a replament. or do i have to buy a new t.v. maria

Posted by on

  • Anonymous Aug 13, 2008

    hello
    i need a new 52 inch screen to replace the one that is currently on my phillips t.v. is it possible to just buy a replament. or do i have to buy a new t.v.
    maria ser. #ya1b0349028289

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Projection T... Master
  • 8,617 Answers

Whats the model number of your phillips? Please respond to this same post when replying and I will try to help you out with your problem.

Posted on Aug 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kids cracked the screen to my 52 inch magnavox tv


No,not practical LCD Screen or DLP CRT Screen replacement it cost the same as a new tv even cost more after labors.Sorry now only can use as salvage electronics boards parts only.

Mar 10, 2010 | Projection Televisions

Tip

RCA 52 INCH PROJECTION TV SCREEN RATION


I ALSO HAVE A 52 INCH RCA (2 YEARS OLD) I HAVE TRIED ALL OF THE TIPS THAT HAVE BEEN DISCUSSED. LUCKILY I PURCHASED THE EXTENDED WARRANTY ON THIS UNIT.. AFTER A MONTH OF OVER THE PHONE TROUBLE SHOOTING FROM WARRANTY REPAIR CENTER THIS INCLUDED REMOVING THE BATTERIES IN CASE THE REMOTE WAS BAD. THEY FINALLY CAME AFTER IT YESTERDAY. THE PICKUP BOYS SAID THAT THEY ARE HAVING A LOT OF TROUBLE WITH THESE UNITS DOING THIS SAME THING. THEY ALSO SAID THAT SOME WERE BEING REPLACED WITH NEW ONES. NOT SURE IF RCA OR WARRANTY IS REPLACING (MINE WAS PURCHASED FROM BESTBUY WITH BEST BUY WARRANTY). IF ANYONE HAS SPOKEN TO ANYONE ABOUT A REPLACEMENT PLEASE RESPOND. I THINK IF THERE ARE SOME UNITS BEING REPLACED WITH NEW ONES WE ARE MORE THAN LIKELY GETTING THE SAME DEFECTIVE UNITS (WHICH WILL MORE THAN LIKELY WORK UNTIL OUT OF WARRANTY). I WISH THEY WOULD JUST GIVE REFUNDS OR CERTIFICATES TOWARDS NEW DIFFERENT UNITS MAYBE IF THERE WERE ENOUGH COMPLAINTS THIS MIGHT BE CONSIDERED.

on Jan 03, 2008 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

Recently my wd-52327 said it needed new bulb(steady orange light). i had replaced the bulb 7 months earlier and didn't want to see the light so i reset the lamp timer. well the bulb blew the next time i...


If you have a voltage meter you can pull the bulb out and check for continuity by placing the probes on the power plugs of the bulb. If you have continuity the bulb should be good, and it may be the lamp ballast.

Nov 21, 2009 | Mitsubishi WD-52327 52" Rear Projection...

1 Answer

Phillips cineos 52 inch have sound but no picture


i have a 52 projection tv phillip and the pic is off you see three images on the bottom nice pic in the middle and on top a little off.so what is the problem

Jul 02, 2009 | Philips Magnavox 51MP392H Rear Projection...

1 Answer

Picture problems


Hello hack9, This problem is due to the possible malfunction of the convergence amplifiers, or the yoke transformers on the CRTs. Now this trouble is repairable, however it should only be attempted by a person knowing the interworkings of a TV receiver. I would suggest that you have a qualified TV Repair Technician repair this set due to the possible dangers caused by the high voltages and currents present. I hope this helps, Thank you, Shuttle83 http://www.electron-age-technologies-llc.com

May 18, 2009 | RCA D52W19 52" Rear Projection Television

1 Answer

Rca 52 inch projection looks like 3-d movie


Open up the back, the convergence ICs are large and attached to a heat sink. They should be marked STKxxx. In most cases, replacing the ICs is enough. Sometimes the feeder resistor fails because of too much current draw. Change the ICs before looking for more parts. Also, try resoldering the ICs. Bad connections can cause this problem as well.
Dan

Apr 09, 2008 | Projection Televisions

1 Answer

52" RCA


The availability will depend upon the model number of the set. Changing it should not be a major problem. I would suggest that you search the web for the service manual that will show you the correct way to replace the screen. The cost of the manual is minimum ($10-$15).
Dan

Mar 18, 2008 | Projection Televisions

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...