An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.
An expert whose answer got voted for 20 times.
Re: image runner 3300 error code
It is a fuser film unit problem,thermistor is a poor contact (or) fixing heater is a problem.
do the following
press additionel function* button at once & press 2&8 buttons at a time and again press additonel function* button.
turn off the machine & on its again.
all the best.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Here's what another tech on here suggested:
posted on Dec 08, 2008
andzulisv Rank: Guru Expert Rating: 89%, 129 votes
thats a fuser error do this in this order additinol function key then the 2 and the 8 key and the same time then additional func key again screen should change to service mode then touch in this order copier function clear err ok turn off with main switch turm back on if it doesnt clear you have a bad fuser
Good luck, hope this helps.
Empty the waste toner container. From left side of copier you have small cover with one screw.Remove the cover and empty the container and clean it very well, you may use alcohol for the neck of the bottle to ged rid of of antistatics.
I researched the solution for error code E000602-0003: Your hard drive
is going bad. Using the DSK CHK utility (1&9 while powering up) may
fix the bad sector and get rid of the error by trying HD clear &
then HD check for every sector in service mode , but more likely than
not, the error will come back. You can try to upgrade the system
software as well. If nothing works, you need to get the HDD replaced.
This problem happens alot in these models. Hope this helps.
turn off copier on the left side lower left to the rear there is a cover with one screw holding it in. remove screw and cover behind it is the waste toner bottle.. Empty bottle then at the top of the bottle is is 2 little circle indents (windows) clean those indents inside and out put bottle back in turn on copier that should do it good luck