It blinks and water will not drain. - Washing Machines

https://images-na.ssl-images-amazon.com/images/I/91XY99CbqSL.pdf

You have a water drain error. http://appliancehelponline.com/samsung.html
The Water Drain error can be cleared by turning POWER SW OFF and back ON.

This type of unit does not drain into the outside unit. It drains into a nearby interior drain, or just to the outside near Inside unit. If the unit is cooling properly, you're ok.

F8 failure (slow/no draining)

In a consumer cycle, the appliance is indicating F8 E1 (slow/no draining). This is because of wrong signals from the circulation pump read by the control board and interpreted as "water present", when there is no water. During draining (and in fact, there is no water), the failure occurs.

1. Check if drain hose is not closed/clogged
2. Drain pump faulty, harness or wiring faulty, control board faulty
3. If machine is equipped with OWl, issue might be caused by damaged or dirty OWl. Clean the sensor lenses then , if issue is not solved, replace OWI (optical water indicator).

Dado

I have a he gtup270emww washer used very little. The washer was overloaded and quit working full of heavy wet clothes and water. The washer agitator does not operate. The water does not drain.

The light blinks. I have un plugged the washer to reset the motor and lifted and closed the lid 7 times. I drained the water by hand.

When I try to operate the washer, it adds water for 30 seconds, the water shots off and the green light blinks.

What is the fix?

The "water light blink" is an indication the water collection tank needs to be drained. Depending on the unit you have, most drain plugs are on the rear of the unit, just above the floor. You can drain it into a low sided pan or bowl capable of holding up to 1 quart of water or roll it to a floor drain or outside and drain it there.

I hope I was able to help you and thanks for choosing FixYa.

Pump impellor pin broken

When I opened the top drawer the water seems to be accumulating in the drawer and no water is draining. The drain tube appears normal and not kinked in any way.

The intake/drain light blinks. How do I fix this problem?

WHAT IS WRONG WITH YOUR WASHING MACHINE
http://www.repairclinic.com/0088_11_1.asp