Question about Mitsubishi WD-52525 52" Rear Projection HDTV

1 Answer

Capacitor help. Hi there, I ordered a replacement kit of the capacitors for my Mitsubishi WD-52525 52 inches when trying to uninstall one of the ones that blew out, the attachments to the bottom of it, stayed stuck on it, as it broke off while trying to pull it up. How can I fix this problem. I have one more to go, but I will not move forward until I know how to properly remove the capacitor in one piece. I would truly appreciate all and any help you can give me. Sincerely, a stay a home mom, thanks in advance.

Posted by on

  • 2 more comments 
  • Jasso A Aug 08, 2008

    Hi there, I was not sure how to unsolder the capacitor, but after googling it, I read I can go to Radio S. and buy such tool. So I will continue with the removal and replacement job tomorrow once I get the unsoldering tool, thanks again.

  • bigmatt Sep 01, 2008

    where do you get the kit from?

  • bigmatt Sep 01, 2008

    I need to find this kit as well - where do I get one from? mmoore2b@yahoo.com

  • Jasso A Sep 09, 2008

    Thanks Slinterious, I finally got brave and took a chance on it, and with lots of patience and focus, I did well for my first time. The Tv is well and working just fine now, thanks again.

    By the way if anyone is looking for the kit I bought it herehttp://servicemanuals.vstore.ca/product_...

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 8,617 Answers

Just unsolder the ends of that capacitor and the board will be marked so you can install the replacement capacitor with the correct polarity.

Posted on Aug 08, 2008

  • Sonny Berry
    Sonny Berry Aug 08, 2008

    Yes it cost 14.00 and it has a red rubber bulb on it that you squeeze to **** up the old solder. It makes the job very easy.

  • Sonny Berry
    Sonny Berry Sep 09, 2008

    thats a good site they kit is cheap and they even include the service manual, so its a good deal instead of paying a arm and leg for a repair shop.Congratulations on a job well done.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Mitsubishi green blinking light of death


Hi Jim,

Green blinking light of death on Mitsubishi DLP TV means that the DM failed to booted up. I would advice you to replaced the 7 1000uf electrolytic capacitor on the DM board. Most of the time it fixed the symptoms. Please inquire at tvrepairworld.com if they have an available DM repair kit for V36 chassis (WD-57733 chassis).

Jdvillanueva

Jan 10, 2012 | Mitsubishi WD-57733 57" HDTV

1 Answer

WD-62725 Put new bulb in, plugged up tv and get a green flashing timer light. TV does not come on.


Replace the DM capacitor. You can get the V26 DM rpair kit from www.tvrepairworld.com which has the replacement capacitors and the CD with detailed repair instructions.

Dec 25, 2009 | Mitsubishi WD-62725 62" Rear Projection...

1 Answer

65 inch mitsubishi flickering timer


replace the dm capacitors. You can get the V26 Chassis DLP DM repair kit at the following link. the kit contains the capacitors and CD with detailed instructions.
http://www.tvrepairworld.com/

Jul 13, 2009 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

Mitsubishi WD-52525 picture problem


you didnt mention which two boards you replaced the caps on however each board in the chassis has the same capacitor issue. Sounds like you need either of the four V26 Repair kits. The FMT repair kit, The signal Repair kit, The Terminal 1 or the terminal 2 repair kit

Jun 12, 2009 | Mitsubishi WD-52525 52" Rear Projection...

4 Answers

Mitsubishi WD-62525


What is your problem now ?

What do you require ?

REpost your problem


Jan 26, 2009 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

I have a mitsubishi wd-62725. my tv wont turn on and the timer light wont stop blinking.


Sounds like the classic bad capacitor problem on the DM pwb. You can get the V26 DM pwb repair kit at the following link which will usually repair the issue. Kit contains replacement capacitors and CD with chassis dissasembly and explains which capacitors need replacement.
http://servicemanuals.vstore.ca/

Nov 28, 2008 | Mitsubishi WS-55513 55" Rear Projection...

3 Answers

Mitsubishi tv


ok.
#1. replaced capacitors on power board. DM board FMT board .
# 2 on power board you need to chek caps. 3300mf x 35 v.QTY 2.
# 3 12 capacitor 1000mf x 16 v.
If caps 1000mf x 16 v . looked good. replaced anyway......

Sep 14, 2008 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

Where can I buy two capacitors for my Mitsubishi WD-52525 52 in?


Thats the best place to order them from, as they have the correct replacement cpacitors which are the high temp orgional capacitors. They should have which ever ones you need.

Sep 07, 2008 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

Mitsubishi WD 62327 DLP TV


Can I ask where you got the capacitor kit from?

Aug 17, 2008 | Mitsubishi WD-62327 62" Rear Projection...

1 Answer

Lamp light (lite the color red)


Chances are its the bad capacitor issue on the power pwb, These symptoms will mimic a bad ballast. You can get a repair kit for the V26 PWB PCB at the following link which contains the replacement capacitors and a CD which identifies the board and capacitor location that needs the capacitors changed and also contains the Service manual on that CD, and the entire kit costt less than just the service manual anywhere else. They have free tech support to help you with the repair as well. Heres the link the kits are listed under the repair kit catagory.
http://servicemanuals.vstore.ca/

Jul 11, 2008 | Mitsubishi WD-52525 52" Rear Projection...

Not finding what you are looking for?
Mitsubishi WD-52525 52" Rear Projection HDTV Logo

Related Topics:

491 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1207 Answers

The Knight
The Knight

Level 3 Expert

72670 Answers

Jaime Hernandez

Level 3 Expert

2296 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...