Where does the remote wire go on the kd-g632 - Car Audio & Video

The remote wire is usually blue. Make sure u do not use the blue for speakers. The remote wire should be in with the power wires.

Online manual:
JVCKD-G632

The wiring diagram is on the second page of the installation manual.

the amp remote wire should be blue/white stripe.

Hi There, if you click on the link you'll find a wiring diagram...
http://resources.jvc.com/Resources/00/00/95/LVT1158-002A.pdf
Rich...

Hello jlj2382,

Here's the wire colors for your KD-AR560:

Black = Ground (to vehicle chassis)
Yellow = Constant 12V (power)
Red = Accessory (to vehicle accessory terminal)
Blue/White = Remote turn-on lead (to remote amp)
Orange/White = Illumination (to vehicle light control switch)
Brown = Cell Phone terminal
White = Left Front Speaker positive (+)
White/Black = Left Front Speaker negative (-)
Gray = Right Front Speaker positive (+)
Gray/Black = Right Front Speaker negative (-)
Green = Left Rear Speaker positive (+)
Green/Black = Left Rear Speaker negative (-)
Violet = Right Rear Speaker positive (+)
Violet/Black = Right Rear Speaker negative (-)

Hope this helps.

The stereo with remote is model KD-S600. Unfortunately there was not one for the 550 version.

The turn on voltage that the amp needs comes from the radio wiring harness and it is the blue wire that is in between the red and the white wires on most JVC radios.

Hope this helps and a rating of "FixYa!" would be appreciated for this free information.

Let me know if you need any more help.

Dave

if you have a wiring harness al the wires are color coded to match the after market radios colors. the yellow constant wire goes to 12 volt or battery wire. the accessory wire would be the red wire that is the switched 12 volts. the remote is for the factory amp or an aftermarket amp which turns on and off it would be the blue with white wire.

i don't know which wire is for the remote, but blue is usually for the antenna up/down function.