Question about Whirlpool Clothes Dryer Door Catch W10111905

Open Question

I am wanting to dis-assemble my dryer- model wed6200sw1 and need to install part W10111905. how do i do that?

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
TheMobilian
  • 8220 Answers

SOURCE: how to replace blower wheel on whirlpool cabrio dryer

The threads are backwards. The pulley end of the motor has a flat spot on it where 7/16 wrench fits. I use a wrench to hold that part down and then I basically shove a flat piece of iron actually ot it a tub nut remover tool into the bales at the 3 o'clock position and slam down the a 12 pound hammer. Sometimes the pulley on these breaks. Most times though if you get mean with it you can get it off there in one piece. The cabinet might be fancy but it has the same setup and any roper/kenmore.whirlpool dryer motor with filter in the top. My crappy home movie of how it all goes down

Posted on Jul 24, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change the dryer belt


The Videos below will cover all you need to know: Unplug Dryer and turn off gas supply before dis-assembly.

Video 1-Covers full dis-assembly and reassembly:
https://youtu.be/1eeJvqhHEYY

Video 2 is a bit more helpful in the details of proper belt mounting and alignment:
https://youtu.be/4bHOjysr5nU

Good Luck. This should make it very easy for you. Belt ribs MUST be down onto drum.

Nov 23, 2015 | Maytag Neptune MDG5500AW Gas Dryer

1 Answer

How to remove front panel model mde9700ayw


First unplug the dryer. Then at the back of the dryer you'll see screws that hold the top on remove the screws and slide the top back, sometimes it goes hard , only need to slide a few inches and then you can lift it off. Depending how far you want to go with dis-assembly you would then need to remove the user interface and electronic control, the door switch to remove the front, held by a screw each side. to remove the drum you must remove the belt from the motor and idler pulley. I can more instructions please contact me, if you want , I will send additional info good luck.

Oct 17, 2014 | Maytag Dryers

1 Answer

Model number wed6200sw1


Probably a burned out heating coil, or bad operating or safety thermostat.

Dec 21, 2013 | Whirlpool WED6200S Electric Dryer

1 Answer

Clicking noise in blower wheel area


Remove the rear cover and get the filter chute off there. Clean her up. This dryer is no different than other dryers with filter in the top.
Cabrio service manual

Jul 23, 2012 | Whirlpool Cabrio 7.0 Cu. Ft. Super...

1 Answer

WED6200SW1 TURNS ON BUT WON'T START.


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Aug 01, 2011 | Whirlpool Dryers

1 Answer

How to I remove catch w10111905 from my existing whirlpool dryer


http://www.applianceaid.com/wpdryer_how-to.html

Apr 30, 2011 | Dryers

1 Answer

Whirlpool WED6200SW1 Door not shutting properly, please help.


You will need to replace the door latch and catch assembly. CLICK HERE for the updated kit that will make your door close easier. Using coupon code 1050 will save you some money!

Jan 12, 2011 | Whirlpool WED6200S Electric Dryer

1 Answer

Whirlpool Cabrio dryer problem


Hello my name is Heath the problem is the heating element is probably burned out and will need replace.

Apr 08, 2010 | Whirlpool WED6200S Electric Dryer

Not finding what you are looking for?
Whirlpool Clothes Dryer Door Catch W10111905 Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Sal DeAngelo

Level 3 Expert

2341 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...