Question about Sony MDR-7502 Professional Headphones
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Hello to all who have exhausted all avenues seeking instructions on how to remove and replace Ear Pads on Sony MDR-V6 Headphones.... All that is required is a little patience maybe some fingernails... The Pads simply slip on and off by pinching ends of cuff that is nearest the plastic backing of The Headphones by pulling them from their seat/flange .. i found it easiest to just roll the cuff off using my thumb w/rolling motion away from the plastic backing/housing of the headphones.. no tools required.. they are installed exactally like one would place a tire on a rim.. exact same motion is required as when removing a tire.. i can give no better illustruction than comparrison to tire removal and replacement. Be careful to make sure one end in completely set deeply into one side before attempting to pull opposing side over its side/flange..start on top and work way around to bottom or vise versa.. To get an idea of what you are attempting to do take a close look at new headphone pad rear and you will see the small flap of leather on rear .. there is a small overlap that fits perfectly over the flange.. dont try to force it as you may tear them...
Posted on Nov 14, 2008
You can go to Radio Shack and find some that fit. Although Sony does not sell them as they woudl ofcourse want you to purchase new ones you can buy third party cushions that fit.
Posted on Nov 26, 2008
Okay, cut and strip the cord. There should be two copper wires and (on Sony headphones, at least) a red and a green strand. On a new 1/8" jack, there should be three connections. The middle one is left, and is where the green one goes. The short one on the side is right, and is where the red one goes. The long bit is the common, and is where the copper one goes. Before you solder, however, remember which strand is which, because you have to sand or burn off the colored enamel. (Use a fine grain paper, or use a standard lighter or stick match- anything else might damage or melt the wire)
Posted on Apr 03, 2009
Tips for a great answer:
Feb 12, 2014 | Sony MDR-XB500 Extra Bass Headphone -...
Oct 29, 2013 | Beats By Dr Dre Studio Noise-Canceling...
May 31, 2011 | Sony MDR-CD280 Consumer Headphones
Feb 24, 2011 | Sony MDR-V500 Professional Headphones
Aug 06, 2010 | Sony MDR-V150 Professional Headphones
Oct 23, 2009 | Sony MDR-V500 Professional Headphones
Apr 22, 2009 | Sony MDR-RF970RK Headphones
Jan 27, 2008 | Sony MDR-V500 Professional Headphones
Nov 26, 2007 | Sony MDR-7506 Professional Headphones
94 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: