Question about McCulloch Garden
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Both the OM and IPL can be found here:
Just type "742" in the "Model Search" window and click Search. HTH
Posted on Feb 17, 2010
If it bogs down like it's getting too much fuel, turn the low side screw out about 1/8 of a turn at a time until it will rev without bogging. If it chokes down like it's not getting any fuel, you probably need to open up the high screw a little.
BTW, you can determine which screw is which by looking at the carb at the base of the screw...it will have a L for Low or H for High stamped near it.
Posted on Jul 19, 2010
SOURCE: how do I change chain
As you do not say what model we are talking about, i will go through the standard procedure.
If it has a chain brake make sure this is de activated by pulling the hand guard fully back to the top handle, remove the nut/nuts from the side cover, remove the cover, pull the bar away from the adjuster pawl, this will slacken the chain enough to loop the chain from the bar and off the sprocket, screw the chain adjuster fully back ( this may be in the crankcase or in the side cover ), with the guide bar now fully back loop the new chain over the sprocket, and lay it into the bar rails, with the cutters sharp edge facing away from the saw on the top of the bar ( the chain rotates clockwise as you are looking at it ) replace the side cover, if the adjuster pawl is in the cover make sure the pawl aligns with the hole in the guide bar, refit the bar nut/nuts finger tight, adjust the chain so as it touches all the way around the guide bar, with a gloved hand pull the chain around the bar to make sure it is fully into the sprocket, re tention the chain if required, hold the nose of the bar up and fully tighten the bar nut/nuts.
Once the saw has run for 10 minutes there will be an initial stretch, so you will need to re tention it.
Hope this helps.
Posted on Mar 01, 2011
Tips for a great answer:
Oct 13, 2014 | Garden
Dec 11, 2013 | McCulloch 16 Inch Gas Chain Saw MCC1635AK
May 14, 2011 | McCulloch 16 Inch Gas Chain Saw MCC1635AK
Jul 18, 2010 | McCulloch Garden
Feb 17, 2010 | McCulloch Garden
Aug 28, 2009 | Porter Cable Garden
Apr 15, 2009 | McCulloch Garden
38 people viewed this question
Usually answered in minutes!