Cartridge housing will not certre to change cartridge

the spout seal will be an "O" ring on the end of the spout housing
the cartridge will leak if there is any thing under the cartridge before installing
before installing a cartridge it is advise able to reseat the tap so that the face of the tap is flat and square to the cartridge

Assuming you've recently changed your ink cartridges the first thing you can try is seeing if you've placed the cartridges properly (did you remove all the plastic covering the cartridge so the ink can flow into the printer?)

If you haven't actually changed your cartridges in a while the printer might be registering the wrong ink levels. This will result in your cartridges not being as full as you think.

Another thing you could try is checking the printer head for anything that's keeping the ink from flowing. By printer head I mean the thingy that houses your ink cartridges. Perhaps there's some old dried up ink blocking the way?

You have to squeeze the tabs on each side and pull it out.

for sending text messages :
1.go to your message settings and check the message center number to see if it is correct
2. call to your network operator customer care
3. request the message center number...
4.note it down
5. go to message settings>message center number
6. insert the number which is noted by you and save it


this solves your messaging problem ...
Good luck

i believe that that your car has a cartridge filter (paper filter) that goes into a housing and has a cap that you take off to get to it the filter presses into the cap then you screw the cap back on most of the cartridge filter fell off of the caps and sit in the housings by the time you change your oil next.
chris

its because the ink housing will only aline when the ink is empty its not like any other printer that you can line the housing up. Wait until you run out of ink then lift up the lid and the housing will be alined - its stupid system and epson dont tell you this when you buy the produc

When changing ink cartridge on this printer verufy first that the power is on. Once you lift the lid it will move the cartridges into view so you can access them.

Turn on printer, unplug power supply when carriage moving. Disconnect usb. carrriage can move freely by hand to gap (replacement position).

change battery

followed the recommended procedure for changing ink cartridge,however although cartridge moved backwards and forwards it never stopped in the position to change it but remained under the housing on the right side of the unit