Question about Motorola Cell Phones

1 Answer

I HAVE THE MOTOROLA H700 WIRELESS HEADSET. IT WILL NOT HOLD A COMPLETE CHARGE, WHEN I AM ON IT AFTER ABOUT 30 MINS IT GIVES ME THE BEEPS IN THE EAR TO RECHARGE. WHEN I PUT IT ON THE CHARGER, IT GOES FROM RED TO ORANGE TO GREEN IN ABOUT 10 MINS.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

1. allways remeber never pamper ur battries specially motorola which has a tradition of low battery life for all devices and less useage time per charge.
2 never charege very friquienrly, let the device get discharged till low battery indication then charge it to full and use .
3 if in warrenty report the problem to vender or buy a new one if  used for more than a year. hope this helps u chow::  majorapsingh@gmail.com

Posted on Aug 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to know the bluetooth pairing code for sanyo M1


Well I know for sure the default pin for the M1 is indeed 0000. However I cannot tell you what the pin would be for your specific bluetooth dongle. If I where you I would try 0000, 1111, 2222 and so on
  • As with all Bluetooth headsets, the H700 needs to be paired with the device before it can be used, which is done in pairing mode. In pairing mode, the H700 makes a transmission so that Bluetooth-enabled devices can pick up the device and connect to the headset. Once connected, no other device can connect with the Bluetooth headset. To enter pairing mode on the H700, open the headset boom located near the microphone. After a few seconds the indicator light will turn purple. Once purple, the H700 is in pairing mode.
Searching for the Device With the M1
  • Once the H700 is in pairing mode, have the M1 search for Bluetooth devices. To do this, press "MENU/OK" and choose "Tools," "Bluetooth," "Add New" and "Search." A list of Bluetooth devices will show up on the screen. Highlight "Motorola H700" and press "MENU/OK." Choose "Add to Trusted," enter "0000" and press "MENU/OK." The devices are now connected and ready to be tested.
Testing the Devices
  • Once the devices are connected, test that both the phone and the headset are working properly together. First, place the headset in your ear. Dial a number on the phone and press "Send." If you can hear ringing, the devices are connected properly and ready for use.
    If the connection was not successful, repeat the previous steps and try again. Make sure the indicator light is glowing purple and is steady. If you have connected the headset to a previous device, make sure that device is turned off so as not to interfere with the connection procedure. Once the other device is off, close and reopen the boom to enter pairing mode.

Feb 16, 2012 | Sanyo Cell Phones

1 Answer

I have a Motorola Blue Tooth ear piece that I bought 4 years ago and never used. I have charged it, but I don't know how to link it to my new phone, which is a Verizon LG Phone. The only buttons on the...


Usually you get the headset into pairing mode by pressing and holding the answer button for about 4 seconds, or until the headset beeps. Once you hear the beep you can attempt to pair to it with your phone. It may ask for a passcode which is sometimes '0000' or '1234'. If you could give me the model number of the headset I may be able to find a user guide for you.

Hope this helps

Ray

May 15, 2011 | Motorola Cell Phones

1 Answer

How to pair motorola h700 to my htc hero


on the phone :
go to settings
then wireless
turn bluetooth on
go to bluetooth settings
click scan devices

on headset press and hold power button when its off untill the light stays on

on the phone you should see your bluetooth headset
click it
if you dont press scan devices again
the pin/pair code is 0000 or 1234 usually
you should be good to go

May 05, 2011 | HTC Cell Phones

1 Answer

My droid 2 is not recognizing the motorola hs820 bluetooth device; I have no info on how to set the hs820 to pair


I think I can help here:
Make sure your headset and phone are charged before doing anything else. The blue light on your headset will come on when it is charging, and will shut off when fully charged.
To put your headset in pairing mode, make sure it is completely off first (no blinking blue light). Then hold down the Call button for 6-10 seconds until the blue light stays on. (It will likely flash once and shut off, but keep holding until it is all the way on and stays there!)
From there, go into the settings on your Droid 2 and access the bluetooth connections. Do a new scan for your headset if you don't see it listed, pair, and connect!
http://www.motorola.com/mdirect/manuals/QG-HS820_9494A71A.pdf

Feb 23, 2011 | Motorola Mobility Droid (2 GB) Cell Phone

2 Answers

I am looking to buy a wireless bluetooth stereo headset that is compatable with my Iphone 4... Any suggestions???


I personally own the Jabra Halo, Altec Lansing Backbeat, and the Motorola MotoRokr S9HD
The Jabra Halo is about 50 bucks and goes over the ear with flat speakers.
The Backbeats are about 100, and provide channeling audio via in ear plugs, but not sound isolation.
the Motorola headset is about 100 dollars, but has issues with skipping, especially if the phone is in your back pocket.

Sep 28, 2010 | Apple iPhone 4 Black Smartphone

1 Answer

I have a LG rumor cell phone and a motorola H700 bluetooth headset im trying to figure out how to pair them up


Somewhere in your phone you will find SETTINGS, then CONNECTIONS, then BLUETOOTH, then SETUP. Turn the Bluetooth on, hold the on button until you hear a long beep. The bluetooth is ready to merge with your phone. Now go through all those other steps and have the phone find the bluetooth. the phone is now asking for the CODE#, it is probably 0000. Unless you have the instructions and they show a different code#. If you are having trouble after that with the code # try the last 4 digits of your telephone #..

Jul 27, 2008 | LG Cell Phones

1 Answer

Charging


It's beeping because the battery is completely dead and needs to charge. If beeping doesn't stop after a while of charging, you may need a new battery or a new charger.

Jul 21, 2008 | Motorola Mobility RAZR V3

3 Answers

H 700 motorola headset bluetooth setup


you have to do switch off device when you want to do off the light.
light show the activate mode of headset.


Apr 20, 2008 | Cell Phones

1 Answer

MOTOROLA W385


press and hold the power key for 10sec on the headset and make you r phone BT visible for the phone o paired with it after which it will ask or the pcode 0000

Apr 12, 2008 | Motorola Mobility MOTOKRZR K1 Cellular...

Not finding what you are looking for?
Cell Phones Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorola Cell Phones Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18304 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Are you a Motorola Cell Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...