The car won't start because the kill switch won't turn on or of.How can I turn switch of so I can start the car

I am gonna figure that you verified that all your powers and grounds are good ... but you didn\'t really give much info ... does it not turn over at all, or does it turn over but won\'t start??

You tried it in neutral but did you take it out of park and force it back into park? Just a suggestion since sometimes the switch that tells it that it is in park needs a bit of a nudge sometimes.

It is the kill switch, ever since they but these on used cars they been acting up.

Take out the battery of the remote and leave it out for a while put new ones back in and see what happens

fit a battery isolator inside the car under the dash on the battery earth is the cheapest soloution.Or a wiring diagram to trace the wires to locate the fault which i suspect could be on the radio wiring where 2 feeds are used one a permanant 12v feed and one a switchable feed via ignition switch causing a backfeed if done wrong .

look this link


http://www.neverhotwired.com/vehiclekillswitch/

Done cars have a kill switch if they are low on oil. Check your oil. If the oil is good, it may be the ignition switch.

No kill switch

The Fuel Inertia Switch --- is only on Ford Products
& will not be a problem unless you were in a very heavy hit
Then your car would most likely be totaled

I would think your battery is no good, IF, it is from the factory
& never replaced
Have you not tested it, on the days it won't start?

What does it take to get it started?

Have you checked fuel pressure or had
someone under car listening for the fuel pump ?

When you removed the alarm unit you cut the line to the Starter kill switch that was installed. Remove the starter kill switch which is most likely located under the dash spliced into the ignition wiring harness.

you should take it to a alarm specialist cause there in lies the problem the kill switch is a thing that kills gas from going to the engine the best thing u could do is have the alarm removed