Question about Poulan 14" Chainsaw

1 Answer

Start but engine wouldn't stay - Poulan 14" Chainsaw

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Poulan Master
  • 2,239 Answers

Drain the fuel tank, replace the fuel filter on the end of the fuel hose, refill with fresh fuel/oil mix, now try again, if no better check the condition of the fuel hose up to the carb, any signs of cracking or leakage and it will have to be replaced.

Posted on Apr 08, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Having problem with craftmans lawnmover


You are in the wrong product category.

Jul 12, 2013 | Cars & Trucks

1 Answer

Pontiac g6 drive the car a bit went somewhere got out came back 2 hours later all it did was turn over an wouldn't start has plenty gas left it alone for a bit try to start it it fired right up. So I...


flassed less engine power wth????????? Flashed reduced engine power ! Electronic throttle control problem ! Your best bet ,take it to a GM dealer , buick , cadillac , GMC . You do not have diagnostic test equipment or knowledge to even diagnose this.

Jul 06, 2017 | Cars & Trucks

1 Answer

My 2001 sunfire starts fine.but after i drive for about half hour it will stall and wnt start again for half hour.the oil light stays on when this happens.wassup with this?


This happened with my Sunfire. It was the radiator. The engine wasn't cooling, but the sensor wasn't showing that it was overheating. So the engine would start when it was cool, but as soon as it got hot, then if I stopped it wouldn't start again.

Apr 14, 2012 | 2001 Pontiac Sunfire

1 Answer

Not sure so far ive tested the battery it reads 13when engine is off. It reads 14.34 on and slowly gos down is this a case of a bad dieode in alt. or is my battery bad ,dont have much money and winter is...


if it stays at around 14 volts when the engine is running I wouldn't think that there is any problem with the alternator, but if you have trouble starting the car because there is not enough charge in the battery I would take the vehicle to an auto electrician & have the battery tested ......hope this helps......cheers.

Sep 28, 2011 | 2004 Chevrolet TrailBlazer

1 Answer

Poulan 3600 Timbermaster. Saw hasbeen unused for over a year. I got it to start with starting fluid. Wouldn't stay running or accelerate. I used carb cleaner with engine not running. Now it has too...


Hello; Dump out all the gas in the tank and put in fresh gas with the additive called "Stabil" it is a red liquid you can but at Walmart or any auto parts store. The trick will be to keep it running long enough for the Stabil to degunk the carb. I also had a weedeater that wouldn't stay running and replacing the plug solved the problem, so also try a new plug. They are only 2 bucks! John

Sep 18, 2011 | Poulan Garden

1 Answer

2000 grand jeep cherokee limited 4.7 liter, v8, at first wouldn't start rplaced battery because dead and then replaced starter. ran ok for a couple days. last night started it and hard time with it...


Hi
Pop into to your local garage and have a diagnostic test carried out.
Listen to the advise given. It may save you lots of money, especially if you start the "guessing" game.
It does sound like a part may be blocked or failed though, but the sytem needs to be tested thoroughly first.
Good luck
Roger

Apr 24, 2017 | 2000 Jeep Grand Cherokee

1 Answer

Engine cut off, wouldn.t start 6.0


You need to flush your fuel system completely and get a new fuel filter.

Sep 12, 2009 | 2004 Ford F350

1 Answer

Enigine problem


you have a blown gasket or the is oil in engine

Jun 11, 2008 | 1999 Ford Taurus

Not finding what you are looking for?
Poulan 14" Chainsaw Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Poulan Garden Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Roland W VanLue
Roland W VanLue

Level 3 Expert

486 Answers

Phil Walker
Phil Walker

Level 3 Expert

608 Answers

Are you a Poulan Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...