Question about EliteGroup (L7VMM) Motherboard

1 Answer

Won't even start.. 0.o!

Hey there, This is the first time that my computer has done this. I know a bit about computers and I have tried several things to resolve the issue. Heres the problem: I plugged my computer in, and pressed the power button. the cpu fan, and all connected hardware seemed to power up properly, but the computer did not load my O/S. Or anything for that matter. It didn't even flash the system's BIOS settings. I have tried removing the battery, and resetting the BIOS jumpers. But it still won't start. When first powered up, the hard disk light lights up for about a second, then goes out, and the onboard speaker makes a quiet "pop" as if it is trying to tell me something. But after that, nothing. even the onboard graphics won't bring the monitor out of stand by when I turn it on. Iv'e resolved many issues with my computers and my friends, but this particular issue takes the cake. It has me completely stumped. Any suggestions? I would greatly appreciate it.
A. Horton

Posted by on

  • Styme
    Styme May 11, 2010

    Doesn't matter if you have the CPU fan spins or even if the L.E.D lights up on the motherboard

    Do you hear any type of beep code ?

    If answer is NO then please say a few words for me at the burial .

    Sorry A Horton for your loss

    Please make sure you mark my rating on your issue

    Thank you



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 80 Answers

There maybe something wrong with your memory...
try removing your RAM and turn your pc on. If you hear a beep then there maybe hope in your pc. re-install the RAM and try switching your pc.


If you have an extra Power Supply unit, try replacing it.

hope this post helps :)

Posted on Aug 07, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How i make a virus which totaly damage my computer

Well, if your using pre-windows 8 Operating System, there is an old fashioned DOS command (s) that when run before windows starts up (with only two lines of DOS code) will routinely proceed to delete your hard drive a file at a time. If done right it will delete your windows directory a file at a time on high speed... and you won\'t have any clue it\'s doing it until its way too late. And no. Anti virus wont get it because it runs as a rootkit and gets loaded long before your software. Will I tell you those two DOS commands? No. I won\'t. Why would you WANT to make a virus? Why would you want to destroy your precious computer system? Well, All i can say is first learn to spell correctly, then know the consiquences (ya I spelled it wrong lol) of making a virus. it\'s called VIRUS or MALWARE for a reason. It uses non standard code that chips off a bit by bit peice of code everytime it runs which results in malfunction. Even of your machine. So take it from someone who knows: Do NOT make a virus or malware. Hope this answered your strange unrelated to fixing laptops question. Final is: DO NOT attempt to create a virus!!!!!! You will more than regret it.

May 29, 2013 | Computers & Internet

1 Answer

06 trailblazer trouble with anti theft system, I think, starts right up then other times the anti theft light comes on and it won't start. can try it 2-4 hours later and it starts right up????

The first thing to do get it checked for DTC'S - diagnostic trouble codes . Not at auto zone or any other parts store , you want to have full scan of all the modules on the car. Don't know how much you know about automotive electronics , computer controlled systems etc.... Your vehicle has at least 10 modules (computers ) on board , there all talk to each other on a serial data network . C.A.N - controller area network . Or in the case of GM it has it's own . GMLAN -
How to Diagnose Controller Area Network CAN When you turn that ignition switch to start it is an input to the computer ,be it the PCM or BCM ..

Jul 01, 2017 | 2004 Chevrolet TrailBlazer

1 Answer

VISTA PC DOES NOT STAT laptop vista battery went down to 10% Vista was shut down and was connected to power supply try several times to start the pc but it just does not start if pc is shut does the...

The battery continues to charge if the computer is off. The computer probably won't turn on because the battery is so low. It might not be charging because the power cord might not be plugged into a wall plug that is on. The plug might be on a switch. Find a plug that you know for sure that is on then plug it in there and try again.

Jul 29, 2011 | Computers & Internet

2 Answers

My wife's 2002 Alpha Spider 2.0 TS has intermittent starting problems due to the key coded engine immobilizer. When this occurs, she leaves the car for 15-20 minutes and usually it will start. I have...

hey i have done a bit of work with alfa's the problem is if the key malfunctions it will register a code in the computer and even if you fix the key it will not work properly, the best thing you can do is find a dealer with a alfa scan tool and they will reprogram the key... its a quick job that can ONLY be done on an alfa tool and beware you may need a new key, sometimes they just go .

Feb 10, 2010 | 2002 Alfa Romeo Spider

1 Answer

Blue screen on start-up saying 'stop: c000007b bad image' etc

Errr...sounds like fun.

OK well I would stop trying to get Windows back in working condition until after you backup your files.

The easiest way is to remove the hard drive from the system and place it into a usb enclosure.

Backup the files and then reinstall windows.

If you try the band-aid method you'll just end up wasting your time.

Hope this helps.

Jun 13, 2009 | Dell Inspiron 1300 Notebook

1 Answer

Printer won,t download to new computer

Here is the link to the driver for your printer:

I hope this helps and allows your printer to function. If you have any other questions, let me know.

Jan 09, 2009 | Lexmark Office Equipment & Supplies

1 Answer

Cartridge error 50c

Have you tried the Lexmark Knowledgebase?

It addresses this specific issue. It sounds like a shorted cartridge. However, sometimes this just means that the contacts in the cartridge carrier need to be cleaned. You can do this by removing both cartridges and cleaning the electrical contacts on the cartridges as well as the ones they touch in the cartridge carrier on the printer. You can do this with a slightly damp soft cloth. You can also use a bit of rubbing alcohol as well.

I would try cleaning the electrical contacts as I described above before I'd do anything like getting new cartridges. If the problem persists after that and after following the instructions in the link I posted above, then it might be time to get new cartridges.

Aug 31, 2008 | Dell A940 All-In-One InkJet Printer

1 Answer

Toshiba a60???

if this happens even if your laptop is plugged in to a power source it could be that your battery is dead and you need to replace it

May 21, 2008 | Computers & Internet

1 Answer

Disc Cleanup and Defragment

hey try doing this in safe mode.

If your computer is running Windows XP or Windows Vista

  1. From the Windows Start menu, go to Turn off computer and click Restart.
  2. As the computer restarts, watch for a progress bar at the bottom of the screen. press F8 about once every second.
  3. Immediately press F8 before the progress bar reaches the right side of the screen.
  4. From the Windows Start-up menu, highlight Safe Mode and press Enter.
  5. Wait for your desktop to appear, and then make the necessary repairs (for example, uninstall programs or devices).
  6. When the repairs are done, restart the computer, and allow it to boot normally.

Dec 20, 2007 | Dell Inspiron B130 Notebook

Not finding what you are looking for?
EliteGroup (L7VMM) Motherboard Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top EliteGroup Computers & Internet Experts


Level 3 Expert

781 Answers

Alun Cox

Level 3 Expert

2678 Answers

Jerry Umali

Level 3 Expert

979 Answers

Are you an EliteGroup Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides