Question about Audio & Video Receivers

3 Answers

Goldwing radio t is a panasonic honda radio cassette player out of a 1986 goldwing when searching for a radio station thee is a very loud interferance through the main speakers and some times both speakers dont work

Posted by on

  • jsherer May 11, 2009

    I have the same problem on my 1986 GL 1200 Aspencade. The radio speakers have real loud interference through the speakers. Sometimes I can get stations to come in, but rarely without interferece to the point where I can hear nothing else.

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

For the Aspencade GL1200

Remove the radio and get a small fingernail file and clean each prong on the radio and the plug in the dash, once you are done pull each prong up about halfway on the radio and re-insert into the dash. WaLa...

The mute button volume is controlled by the center knob on the radio, you can set it anywhere you like.

Posted on Dec 06, 2009

I have goldwing 1984 just bought, the radio doesn't work. seems like all controls, am/fm runner work
just don't have any sound. Does the mute switch on left handle bar effect any ? any one has experience will be appreciated. allen@jofforts.com

Posted on Oct 19, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Allen@jofforts.com

Try checking the wires to your potentiameter. (Front/rear speaker control knob.)

These wires can break at the soldered joint.

Posted on Oct 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 83 Honda Goldwing with a Clarion cassete player model # PH-890V There are seven wires that connect to the bikes wiring harness as follows blue, yellow,and green about 18 ga. Then there is a red...


the red is your constant voltage, the the yellow is your accessory voltage(used when you turn key this holds the memory in the deck. the black is the ground the blue and green are the speaker. the white is the ground for speakers as is the small black wire.. please rat this...thanks

Sep 02, 2008 | Audio & Video Receivers

1 Answer

Been trying to get the radio station to program.it hasn't been working. On my RX-590


If you are using automatic channel search, disable it and use manual tuning to find the station then program it. If the signal you are seeking is comparatively weak compared to others, the tuner will skip it in the automatic search mode.

Oct 20, 2013 | Pioneer Rx-590 Home Stereo Double Cassette...

1 Answer

Need nline manual for panasonic RS262 Cassette Stereo tape deck


They don't even have it on the Panasonic website. Maybe you should contact them and ask if it exists or use a web search to see if someone is selling a scan.

http://www2.panasonic.com/consumer-electronics/support

Jul 20, 2011 | Panasonic Audio & Video Receivers

1 Answer

Lost remote cannot operate tunner,cannot get radio stations. I can play cd player and cassette that is all.


If you know the model of the device (which you did not mention) try here:

http://remotes.com/store/

http://www.electronicadventure.us/

or eBay: search for "(model) remotes", check the 'include description' box. Usually cheaper than the vendors.

Jul 19, 2011 | Audio & Video Receivers

1 Answer

I just bought the RCA CD/DVD home theater system RTD206. I cant figure out how to change the radio channels. Also cant figure out how to change the cd disk tracks. Does this system have a remote. Or do...


The system does have a remote (at least it should come with one if purchased new), and you need it to control pretty much everything. Here's what the manual says about the radio tuner (you can find the whole manual here) :

Manual Tuning
1. Connect the FM aerial and the AM loop antenna at the back of the unit. Rotate the AM loop for
better reception.
2. Press TUNER to enter TUNER mode and toggle between FM and AM.
3. When the FM station broadcasts Stereo sound, ST is displayed.
4. Tune a station by pressing repeatedly the TUNER+/- buttons until the desired station is found.
Alternatively, you can press and hold the same buttons down for about one second to activate
the automatic search function. In this mode the player will automatically tune frequencies until
it finds a station.
5. Repeat step 4 to tune to another radio station.

Storing radio stations
The player can store up to 30 radio stations in its memory. You can enter every single radio station
yourself or the player can store all available radio stations automatically in ascending order.
Automatic preset programming
1. Press TUNER to enter the Tuner mode.
2. Press and hold TUNER down for 3 seconds to start automatic preset programming.
Note: A weak signal can affect the "Automatic preset programming" function's efficiency. Adjust the aerial for better
reception and a more efficient search.
3. Radio frequencies will be browsed and radio stations stored automaitcally. When all the available
radio stations are stored or all 30 memory locations are full, the auto preset programming
function will stop.

Manual preset
1. Tune to a radio station (see "Manual tuning" for details).
2. Press MEMORY once to enter flashing Preset Loaction number.
3. While the Preset Location number is still flashing, input your desired preset number (1-30) using
the numeric buttons or press the CH+/- buttons, then press MEMORY to store it.

Retrieving preset stations
1. Press TUNER to enter the Tuner mode.
2. Press CH+/- to search up or down for the preset stations or directly press the numeric buttons.

As you see, you really need that remote. The same is true for disc play. While there are front panel buttons for play/stop, disc skip, and drawer open/close, you don't have any other control without the remote. Without the remote control you'll find this system won't do too much, unfortunately. If you bought this new, check the packing material before you throw it away to make sure the remote's not still somewhere in the box. They often come tucked into slots on the foam inserts.

Also, when you hook the unit to a TV, it's just using the TV as a video display device. The TV has nothing to do with any of the system's other functions.

I hope you have luck locating the remote! Thanks for using Fixya.

Jun 29, 2011 | Audio & Video Receivers

1 Answer

How do I preset the tuner for radio stations. I've never had a problem doing this with any other stereo. But what I think should work isn't!


Not very specific. Do you have the manual?

The following is from a VSX-03TXH manual. It ain't pretty but it may help.

I'm posting it in multiple parts due to space contraints.

37

Chapter 6:

Using the tuner

Listening to the radio

The following steps show you how to tune in to FM and

AM radio broadcasts using the automatic (search) and

manual (step) tuning functions. If you already know the

frequency of the station you want, see Tuning directly to a

station below. Once you are tuned to a station you can

memorize the frequency for recall later-see Saving

station presets below for more on how to do this.

1 Press the FM/AM button to select the tuner.

2 Use the FM/AM button to change the band (FM or

AM), if necessary.

Each press switches the band between FM and AM.

3 Tune to a station.

There are three ways to do this:

Automatic tuning

To search for stations in the currently selected band,

press and hold TUNE ?©/?? for about a second. The

receiver will start searching for the next station,

stopping when it has found one. Repeat to search for

other stations.

Manual tuning

To change the frequency one step at a time, press

TUNE ?©/??.

High speed tuning

Press and hold TUNE ?©/?? for high speed tuning.

Release the button at the frequency you want.

Improving FM stereo sound

If the TUNED or STEREO indicators don't light when

tuning to an FM station because the signal is weak, press

the MPX button to switch the receiver into mono

reception mode. This should improve the sound quality

and allow you to enjoy the broadcast.

Using Neural THX

This feature uses Neural Surround™, THX® technology to

achieve optimal surround sound from FM radio.

• While listening to FM radio, press AUTO/DIRECT for
Neural THX listening.

Dec 23, 2010 | Pioneer VSX-07TX Receiver

1 Answer

Stereo radio with cassette player has static only from the rear speakers and no sound.


are they factory speakers or aftermarket? is the radio factory or aftermarket?

May 09, 2009 | Audio & Video Receivers

1 Answer

What radio station do I need to have on for the cd player to work?


none you need to connect the CD player to the reciever in the CD input on the back and select that input and you should hear your CD player playing

Jan 25, 2009 | Audio & Video Receivers

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

861 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio & Video Receivers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

68301 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Are you an Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...