Question about Garmin GPS 128 Receiver

1 Answer

128 garmin ; takes long time to pick up signal and most the time it dos nt and keeps turning off .should i buy a sledge hammer

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Legend:

    An expert who has written 200 answers of more than 400 characters.

  • Expert
  • 332 Answers

I wouldnt do that just yet (hit it with a sledge hammer I mean...lol) First make sure its fully charged up that could cause a delay and also cause it to keep turning off on you. After a full charge if it continues to do this then go to www.garmin.com At the top right of the page click on My Garmin and either set up an account or put your user name and password in if you know it. Then go to technical support and ask them about repairing your unit. Explain to them what it is doing and what would the cost be to have it repaired.

I hope this helps you out if it does please leave me a Yes that I did help you with your problem. Thank you.

Posted on Apr 07, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi I can't get a wifi or internet signal on my m8s pro tv box. The date is stuck in the 1970. Please could you help me sort this problem out before I take a sledge hammer to it!!


Go in to the settings to change the date i changed the date on mine and it did the same
There should be a few other settings make sure you have it set to automatic date and time then save
Hope it helps

Sep 28, 2017 | Internet Computers & Internet

1 Answer

What is a F90


A sledge hammer will just cause more problems ;-). You might try holding the light switch in when putting it in clean. Cycle through the clean cycle and then shut off the clean cycle. this may let the lock motor reset to open. There is a possibility the lock motor has gone bad. This may need a repairman.

Oct 06, 2014 | Kitchen Ranges

1 Answer

Epson NX420 W-03


Disconnect the printer - take it outside - pound it 6 or 7 times with a sledge hammer - throw it in the garbage - go out and buy a laser printer. This printer is a piece of junk!!

May 23, 2012 | Epson NX215 All-In-One InkJet Printer

3 Answers

All lug nut are off and the rar wheel will not come off.


The wheel is likely rusted in place or held there by dried mud/crud. Remembering that the truck is supported by a flimsy jack, smack the top of the tire with a small sledge hammer or rubber mallet -- it should pop loose.

Dec 22, 2010 | 1997 Nissan Pickup

2 Answers

Unable to remove tire to change it even after removing all lug nuts ... is there some type of locking mechanism?


GIVE SIDE WALLS QUICK SWIFT KICK.DONT BREAK YOUR FOOT OR USE A LARGE RUBBER BLOW HAMMER HIT SIDE WALL SHOULD COME OFF.MAKE SURE VECHICLE IS OFF THE GROUND ENOUGH WHERE BOTTOM PART OF TIRE STILL DONT HAVE SOME VECHICLE WEIGHT STILL ON IT.

Oct 20, 2010 | 1995 Dodge Intrepid

1 Answer

I have a mtx thunder 7801 and a sledge hammer box


Sounds like the subs are blown with the voicecoils fused together which means the amp is/was seeing a dead short ( zero Ohms reisitence) not good for any amp. Disconnect the speaker terminals from the amp and see if it turns on. The funny smell might have been the subs blowing up, i'll keep my fingers crossed for you.

Feb 28, 2010 | MTX Car Audio & Video

2 Answers

My Garmin 765t stopped navigating


There should be a small reset switch on the back of most garmin gps units. with the unit on, depress the reset switch with a pen tip or small object until the unit shuts off and restarts. It may take a little longer to pick up the satellite but it will reque the unit and unlock the navigation screen.

Aug 01, 2009 | Garmin nuvi 765T GPS Receiver

1 Answer

No satellite signal pick up


Yes ! 3 years is at the end of the expected lifespan of the battery

Jun 30, 2009 | Garmin Forerunner 205 GPS Receiver

2 Answers

Unknown disc error and whirring sound!


Do you leave the unit on all day and night on standby?

If this unit gets to hot you can experience this problem I suggest that you turn the power OFF totally until the unit cools down and try again. Normally 15 mins is enough.

Feb 01, 2009 | Philips DVDR3380/05 DVD Recorder

Not finding what you are looking for?
Garmin GPS 128 Receiver Logo

Related Topics:

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garmin GPS Experts

SHARCNET-USA
SHARCNET-USA

Level 3 Expert

2130 Answers

yadayada
yadayada

Level 3 Expert

80417 Answers

Steve

Level 3 Expert

3289 Answers

Are you a Garmin GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...