Question about Troy Bilt 17 Inch 29 Cc Gas Powered Clutched Curve Shaft Trimmer #41ADT52C966

1 Answer

Homelight MightyLite 17" Straight Shaft Trimmer

Manual needed. I installed GrassGator trimming blades in head and cannot figure out how to remove head to install new blades

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

A lot of times there is a hole in the side of the head to insert a rod into so the head doesnt spin..now all you have to do is figure whitch way it turns as some a left hand thread

Posted on Aug 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you convert the Echo grass trimmer model SRM-22ges to the brush cutting option?


There is a hole just above the grass trimming head that you can slip a screw driver into. Turn the head so that the inner and outer holes align where you can put a screw driver or other hard steel object in. Put it in there and then turn the head counter clock wise until it comes off, it may take a little effort to get it to move, but you should be able to do this with your hands. Once you get the trimmer head off, put the blade on and hopefully you still have the nut and washer accessories to hold the blade in place. You will need to place your screw driver back in the alignment hole to hold the head from spinning while you tighten the blade nut back down. Make sure it is tight, you don't want that blade coming off at ~10,000 rpm!

Aug 23, 2014 | Echo Lawn Trimmers & Edgers

1 Answer

Why did my weedeater lost power when trimming on grass but still spun?


There is a cable that runs from the motor to the trimmer head check that. Remove trimmer b.y removing small screw at the base of trimmer head

Aug 05, 2014 | Troy-Bilt 25cc 2-Cycle Curved-Shaft Gas...

1 Answer

I have a Echo Gas trimmer SRM-210 Rapid feeder dual line. I need to know how to remove the entire drum for the string spool? NOT how to re-string but how to replace entire head/spool, as if I was going to...


In your manual under section 12: Line Head Installation. You will do the opposite of what it says here. The key is to LOCK the gear drive so the flex-drive shaft won't turn WHEN you are removing the trimmer head. They use a special tool (maybe you have it). But a small-shafted Phillips screwdriver or the like can be put in the drive hole to lock the gearing up as well. Look for the hole in the upper plate and align with the notch in the drive housing and grasping the entire string head unit, remove it. Here is your manual, see Section 12

http://dl.owneriq.net/8/854215d5-44e4-4b5d-b773-77b331fd73b3.pdf

Jul 17, 2011 | Echo Rapid Loader, Trimmer Head

1 Answer

Shaft heating up next to trimmer head- smoking polan pro150- and how to remove head for service


You can wrap a rag around the threaded end of the string head shaft after removing the bump knob to hold in place while turning the upper part of the string head counterclockwise to remove. Then you can do the same to remove the metal shaft adapter nut above that, exposing the flex shaft in its entirety.

Aug 14, 2010 | Poulan/Weed Eater No. Te475 952711797 17"...

1 Answer

Manual


Typically 32:1 to 40:1 for all these models. Use 35:1 and modern 2 cycle oil and you will be fine. :)

Apr 29, 2010 | Poulan 17" T&E Gas Trimmer

1 Answer

Starter rope


First, i will take that the rope is in the front. If so, you will need to remove trimmer shaft,throttle assembly, so you will be able to remove starter housing.

May 13, 2009 | Homelite Mighty Lite Lawn Trimmer

1 Answer

I need a manual for a Homelite Mightylite 17 inch Curved Gas Trimmer with EZ wind Bump Feed UT 21907 Ser #642287


Go to homelite.com then click on service and support, then click order parts then click launch homelite parts catalog, Agree to terms then click continue under model no type in mightylite then find you trimmer in list.

Apr 12, 2009 | Homelite Mighty Lite Lawn Trimmer

1 Answer

How to change blades


Use a large pair of pliers to hold the turning metal ring above the T35 trimmer head. I used a medium-sized pair of Channel Lock pliers. Then, turn the trimmer head counter-clockwise and it should unscrew from the mount. There's no need to open the trimmer head for this operation. Then, follow the parts diagram in the trimmer user manual to install the blade parts in the right order.

Mar 16, 2009 | Husqvarna Lawn Trimmers & Edgers

1 Answer

Replace a flexible curved shaft


If you go to www.homelite.comin the red area up top click on order parts then click - click to launch homelite parts catalog, then scroll down thru agreement and click agree and then you will need to know your model number and you can get a breakdown of your trimmer wich will give you a good idea of how your machine is put together.

Dec 16, 2008 | Homelite Mighty Lite Lawn Trimmer

Not finding what you are looking for?
Troy Bilt 17 Inch 29 Cc Gas Powered Clutched Curve Shaft Trimmer #41ADT52C966 Logo

380 people viewed this question

Ask a Question

Usually answered in minutes!

Top Troy Lawn Trimmers & Edgers Experts

Jim Parker
Jim Parker

Level 3 Expert

1040 Answers

Dwain Pippen

Level 3 Expert

376 Answers

Wade Mobley
Wade Mobley

Level 2 Expert

448 Answers

Are you a Troy Lawn Trimmer and Edger Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...