My arc mouse suddenly stopped working on my Toshiba Satellite L650 yesterday though i tried it with 2 other laptops it only doesn't work on mine but the keyboard curser is working, What do I do to make my arc mouse respond please ??

I think you are going to be out of luck on this one, if no hardware support is available it will make it impossible to come up with a solution, but there are forums out there that go places where windows does not go, try a general search on the internet, you may find what you are looking for.

You may have to try and do System Restore on your PC to a period in time when all your buttons (keyboard refers) worked.

Another alternative is to Uninstall the most recent program you installed and you started experiencing a faulty right mouse button on your PC

Hi there!
There are two possible driver for your Toshiba L650 sound device. One is from ATI and the other one is from Conexant. (click on the name to download the driver compatible)
Try installing the ATI first. If that doesn't work, then install the one from Conexant.
Hope this helps.

The first thing I would try is shut down and restart the laptop, if this does not work try reloading the driver for the mouse.

if it works with a mouse plugged in you might have accidently turned the mouse pad off, use FN key and on mine it's F7 to turn it off and on. hope this works for you

next to the F1 key and the windows key (2nd upper key and second to last key) are two screws, usually under some covering. unscrew and lift top edge of the keyboard towards the trackpad to lay face down. Undo the wire ribbon by lifting the grey or brown tabs and remove ribbon and keyboard. Then install the new keyboard by inserting the ribbon on the place. Lock down with the tabs and put the plastic prongs (close to the space bar) into the laptop body first, and then close keyboard onto the final position. screw back in and thats all. [email protected] for any additional questions.

I had a similar problem: brand new arc mouse. Used it with the supplied batteries which ran out of juice yesterday. Put new batteries in this morning and the cursor wouldn't move at all. Tried every port, other computers etc but nothing. The tranceiver was connecting fine and being detected. The mouse was showing the green light as it should when you unfold it.
In the end i uninstalled intelipoint and was about to take the mouse back to the shop where i bought it. I gave it one more try and it worked!
So to cut a long story short - just try uninstalling the microsoft mouse software. Hope that works for some of you.

Ok so here goes.... I had the same problem:

Go to the 'start' button and then hit the 'control panel' option, then click 'mouse' then go to 'Device Settings' and then to the 'settings'. When you get to this screen it shows a list on lthe left hand side choose the 'tapping' option and then ok.

Hope it works for you...it did for me.

press and hold fn and press f11.it sounds like you activated the sticky keys

I have a Toshiba Satellite laptop and experience this problem with the mike stopping suddenly too. Your solution may not be as easy as mine was, but here goes ... Did you check the audio setup? Go to Audio Properties, and click Advanced so you can see the Microphone properties. Mine was muted and it wasn't me that muted it -- just seemed to happen suddenly and hopefully it's that easy for you!!!!