Question about Philips 170S5FB 17" LCD Monitor

1 Answer

After 1sec down - Philips 170S5FB 17" LCD Monitor

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 36 Answers

Is it going into Standby? It could be that one of your Cables is not connected properly. Or you are on the wrong input. ex: VGA instead of DVI.

Posted on Apr 06, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Nokia 6500 slide - RESTRICTION CODE

Try this one:

1. Press ( # ) on your phone
2. To get ( p ) press ( * ) 3 times within 1sec
3. To get ( w ) press ( * ) 4 times within 1sec
4. To get ( + ) press ( * ) 2 times within1sec
5. Enter the 15 digit code
6. To get ( + ) press ( * ) 2 times within 1sec
7. Enter code number
8. Press ( # ) on your phone
Now your phone is unlocked!
If your phone isn?t unlocked after code 1 or code 7 then you have either entered the wrong IMEI or Network. Sometimes there could also be a problem with newer software versions.

Hope that helps......

Sep 02, 2008 | Nokia 6300 Cellular Phone


Use slow shutter speed in NIGHT

To obtain a good picture of the garden or nature leave the shutter open for 1sec and see the results !!

on Mar 10, 2008 | Nikon F5 35mm SLR Camera

1 Answer

What causes a unit will turn on for about 1sec and then shuts down with the letters EEon display

EE is an ERROR code typically it is a disconnect from the control and the unit, this is inclusive I believe so the thermistor or sensor is bad or off at the board.


Jun 06, 2014 | Fedders A6Q10F2B Q Chassis Room Air...

1 Answer

Visco vsc20v1 will not powers on and right back off

How many times this standby/power light blinks at one time switch ON? Count it carefully. These blinks are fault indication, and known as blinking codes. From the number of blinks occur at one time switch ON; you can get an idea about the faulty circuit stage inside the TV. This will make repair easy. For more information, check the link

Nov 22, 2013 | Element Electronics FLX3711B 37 in. LCD TV

1 Answer

Changing the window switch in a 1999 Mercury villager

check whether the windows has to be reset if I am right according to some vehicles I know just sit in the car turn the ignition on, and try from your main window controller by pressing both buttons of the opposite window you changed the switch for down 1sec, up 1sec and do it up to three times and see what it comes. If it is the same check it with an electrician.

Aug 24, 2012 | 1999 Mercury Villager

1 Answer

Ds turn off on its own soon as u turn it on it flash for 1sec and turns off on its own .

Reset the system. Just hold the select or start button when you turn ds on.

Dec 17, 2009 | Nintendo DS Lite Console

1 Answer

Cannot set ringtone id to a specific number

to do so the ringtone length has to be less than 20 sec so basically 1sec-19sec

hope i helped

Jun 30, 2009 | LG Vu CU920 Cellular Phone

1 Answer

Turning the power on causes the screen to display ENVISION for approx. 1sec.and it goes out and stays out. Switching a display signal on through an A-B switch gives approx. a 1sec. display time that does...

Your power supply has burnt out which unfortunately is extremely common in new devices. I do agree that it may be worth fixing if it is only couple years old.

Jun 11, 2009 | Envision EN-7220 17" Flat Panel LCD...

1 Answer

Tv powers off after 1sec being on?

does the led flash when you try to press power after it shuts down, or when it shuts down? If so how many times does it flash?

Jul 18, 2008 | Panasonic PT-47WX49 47" Rear Projection...

Not finding what you are looking for?
Philips 170S5FB 17" LCD Monitor Logo

Related Topics:

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Computers & Internet Experts

Computer Repairing
Computer Repairing

Level 3 Expert

14641 Answers

The Knight
The Knight

Level 3 Expert

74468 Answers

micky dee

Level 3 Expert

2888 Answers

Are you a Philips Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides