Question about Brinkmann Charmglow 810-7600-S Grill

1 Answer

My Charmglow gas grill will stay lit only when I hold the knob in the "light" position. Soon as I let it go it goes out.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 43 Answers

Your burners are dying. www.ibuygrillparts.com

Posted on Apr 25, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oven lights but then flame goes out as soon as I release the knob


The flame sensor seems to be bad.

When I light my pilot light, it stays on till I release the button ...

askville.amazon.com > Home > Home Improvement
Mar 18, 2008 - Similar Questions: light pilot stays till release button suggestions ... If you have held it for a long time and it still won't stay lit, then your thermocouple is bad.... the gas valve doesn't think a flame is burning the gas coming out of the pilot ... less likely but somewhat common is the gasvalve... if the knob you are ...

Troubleshooting Gas Range and Oven Problems ' Back ...

blog.etundra.com > Tundra's Tech Talk

Dec 15, 2015 | Fisher Paykel Fisher & Paykel 24-in...

1 Answer

I have a full propane tank. I bbq'd about 3 weeks ago, same full bottle. Grill will not light. Good spark at ignitor. Used lighter and lit for a few seconds with low flame on high. No other burners will...


Hello,
You may have turned the gas tank valve on too fast. Turn it back off, disconnect it and reconnect it. Then very slowly turn the valve back on. Light one burner at a time and turn to low before lighting the next. If you are hearing and smelling gas with the tank on but all grill knobs off, don't use the grill. You may have a leaking grill valve, regulator or hose. If you are only smelling gas with the knobs on, it's possible you have a clogged burner or orifice from bug nests, spiderwebs, etc and need to clean it out first. Hope this helps. Douglas

Jun 13, 2010 | Brinkmann Charmglow Stainless Steel LP...

1 Answer

I have a brinkman gas grill model 810 8501 s and the searer will not stay burning unless I hold the knob in. As soon as I let go of the gas knob the searer goes out. Any ideas on how to fix?


First I have a couple of questions for your question on how ti fix your Brinkmann Gas Grill, Model 810-8501-S
===============================================.

1). Did you push the igniter for 3-5 seconds after you turned on the Sear Burner (remember, this needs to be done AFTER you've turned the control knob to HIGH).

2). Once the burner is lit, you then need to continue to PUSH & HOLD the control knob for another 30 seconds as this somehow seals the deal, thus this should solve the problem.

3). However, if this does NOT work, you may have a defective Sear Burner and the best thing to do is to contact the Customer Service Department over at Brinkmann:

* The Brinkmann Corporation
Attn: Customer Service

4215 McEwen Road
Dallas, TX 75244
Toll Free:
(800) 468-5252
Local:
(972) 716-4262

OR you may send them an email through this link:
http://brinkmann.net/Customer%20Service/ContactUs.aspx

Hope this helps!

Apr 06, 2010 | Brinkmann Stainless Steel All-In-One Gas...

1 Answer

My living room gas heater will not stayb lit


Try replacing the thermo coupler.There should be a little bulb shaped part(like a pencil eraser) that the pilot light heats up .The other end screw into the gas valve.If this is going bad or has gone bad the pilot light will not stay lit.Most of these are under$10.Well good luck and try to stay warm.

Feb 02, 2010 | Grilling

1 Answer

My electrolux oven won't stay lit


Right above your pilot light, there is a little temperature probe. It either needs to be cleaned, replaced, or adjusted closer to the top of the pilot flame. Hope this helps. Good luck!

Nov 07, 2009 | Cars & Trucks

1 Answer

I live in a mobile home and I cannot light my pilot


Are you sure it has a pilot light? Some of the newer heating systems do not have a pilot light but a glow bar ignition. Lets open up the door and I need you to look for the gas valve. The gas valve will have a number of pipes attached to it and it may have two small pipes that go into the burner box. The gas valve will have a knob on it that indicates On, Pilot and Off. If you have this knob, yes you do have a pilot. Align the Pilot position with a line on the gas valve. Push in or down on the knob. Follow the two small (1/4" and 1/8" pipes into the burner box and with a long match or grill lighter, hold the flame over the pilot assembly. Once the pilot is lit, continue to hold down the knob for a minute or two. Lift up on the knob and see if the flame on the pilot stays on. If it does, turn the gas knob to the On position. If it does not stay on, there is an issue and a technician must be called.

Oct 17, 2009 | Honeywell Heating & Cooling

1 Answer

Grill's fire won't stay lit


Try banging on the tubes feeding the burners with a heavy pair of vice grips or a hammer. It usually shakes the carbon loose to allow for free flow of gas.

Aug 09, 2009 | Grilling

2 Answers

Grill wont stay lit


These new tanks have a safety device installed in them . If you open the valve quickly or tip the jug the damn thang won't work. Take the tank loose, open all the grill valves and close all valves. Reconnect the tank and SLOWLY open the valve a hair. Light the burners. No need to open the valve all the way. if you do the dumb safety will plug the jug.

May 08, 2009 | Brinkmann Charmglow 810-7600-S Grill

3 Answers

Charmglow gas patio heater


My charmglow heater is a yeAr old and the pilot will ignite and stay lit for ever,but when you let up on it it goes out! What cam I do?

Mar 16, 2008 | Coleman (5040B750) Patio Heater

Not finding what you are looking for?
Brinkmann Charmglow 810-7600-S Grill Logo

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Brinkmann Grilling Experts

paulcarew

Level 3 Expert

2458 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Lyle Siemens
Lyle Siemens

Level 2 Expert

328 Answers

Are you a Brinkmann Grilling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...