Question about Black & Decker 19" Electric Lawnhog Mulching Mower with Rear Bag

1 Answer

I have a black and decker hedge trimmer g25?

The wire accidentally got cut whilst trimming a hedge, is there any way this wire can be replaced at any retailer, instead of buying a whole new hedge trimmer as it was only purchased recently???????????????

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 4,402 Answers

Just take it to a electronics service shop that can resolder it for you

Posted on Aug 05, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace antenna on MF 383 tractor


1st im going to assume you've got a rare one with a full house on it instead of a bikini top model (more common)
the antenna for roof top radio should mount like a std car type (hence id obtain a car type replacement) use the cable from old antenna to use as a "puller" tape the new to the old and pull new wire to radio back , this keeps you from removing the entire roof trim to get wire inside . new antenna then just tightens up from outside using pliers (grips to sheet metal) and inside end just plugs into radio back panel simple

Jun 29, 2015 | Garden

1 Answer

Loss of power when blades engaded.


Remove deck belt from blade pulleys and Tri to spin blades by hand. If they don't spin freely, you probably need new spindle bearings but if you do need a new spindle I would replace the whole spindle housing... Just make sure the one (s) you buy has housing, spindle, bearings, nut and washer.

Jul 04, 2013 | Craftsman 17.5 hp 42 in. Deck Lawn Tractor...

1 Answer

Can I replace the wire to my PTO clutch on a Cub Cadet LT1045 or do I have to replace the whole clutch?


if you can take of the black box with a screw driver carefully so you dont break any solder on the actuator for the clutch itself
then trim and splice and put the black plug back in

Oct 24, 2012 | Garden

1 Answer

Put new belt on 42 inch poulan pro, now one side cuts lower than other


Spindle is most likely wore out allowing on blade to drop down lower than the other.( most likely )?? 25+ years small engine mechanic as well as motorsports.(solution buy mew bearings replace or sometimes cheaper to just replace whole spinde with bearings already in it. Hope this helped.Ofcorse could b bent blades ect but most likely the bearings have allowed blade to drop down.

Jun 30, 2012 | Garden

1 Answer

Sparkplug wire has been cut, what should i do


Buy a new coil and replace it, and you will be on your merry way.

Nov 12, 2010 | kawasaki Garden

1 Answer

My hedge cutter smokes


Hi,
Your hedge cutter is toast....motors run on smoke and when the smoke comes out they no longer run....:-)
Given that a hedge cutter is not all that much money to replace... trying to repair it will not be worth it...
Your best bet is to just get a new one...

heatman101

Oct 10, 2010 | Garden

2 Answers

Ryobi rht2660da hedge trimmer starts but will not rev fully and cuts out on full throttle thisproduct is brand new


If it brand new take it back to where you bought it, it's probably still under warranty. Why try to fix something you don't need to???

Aug 30, 2010 | Garden

1 Answer

I get no spark from the spark plug, replaced it with new one still no spark why, echo hedge cutters


please check kill switch and wire for making ground when they shouldnt make contact in the run position

bassically pull the wire off at the stop switch or at the ignition unit if it fires

faulty stop switch or grounding wir indicated

if not faulty ignition unit indicated

replace ignition unit and assemble

cheers paul

Aug 11, 2010 | Garden

1 Answer

Mcculloch Virginia hedge cutter manual


mcculloch virginia mh542 hedge trimmer, fires 1st time, will only tick over roughly on full choke only then stalls when throttle applied, I have fitted new plug'cleaned air filter and new fuel mix but no change.

Nov 25, 2009 | Garden

Not finding what you are looking for?
Black & Decker 19" Electric Lawnhog Mulching Mower with Rear Bag Logo

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Black & Decker Garden Experts

Jim Parker
Jim Parker

Level 3 Expert

1040 Answers

EugenesDIYDen
EugenesDIYDen

Level 3 Expert

479 Answers

Tim Whalen

Level 3 Expert

3069 Answers

Are you a Black & Decker Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...