Printing report on received faxes

To run the auto dial and speed dial report you need to do the following:

Press Menu, 5, 2, then Start. The display will prompt you to the correct numbers. This will give you a list of pre-programmed numbers.

Hi there!
For you to setup the confirmation here's what you can do:
-Press Menu/set 2,4,1 -Press the Up or Down arrow key and select ON you can select On+Image to get a confirmation with the image of the document that u fax. -Press Menu/set to confirm -Press Stop/exit
To print the confirmation page for your last transaction just press Reports and press the up or down arrow key to select Transmission
Hope this helps! Thanks!

I finally located a phone numbe for the Brother-USA Sales Dept. (888-615-9119). The part was $4 plus shipping and handling ($10 total). It took a bit of doing for them to identify the part and determine the part number. I had to fax them a machine parts diagram from the MFC-8220 manual. Go figure.

Is the 1 placed infront of the number, is the line part of a PBX system requiring to dial a 9 to get a outside line.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

If you make a copy and it comes out 1/2 black then you have a bad scanner.

not sure if you have manual, but here it is

http://www.retrevo.com/s/Brother-MFC-8220-Multifunction-Printers-review-manual/id/260ag204/t/1-2/

need to go in the menu and change setting

http://www.retrevo.com/s/Brother-MFC-8220-Multifunction-Printers-review-manual/id/260ag204/t/1-2/

here is the manual try the troubleshooting sectiomn


http://www.retrevo.com/s/brother+8220++fax++manual

good luck

although it may have a time retreival function it will not store 2mo of faxes !! most likely only a few days depending on the amount of fax you receive

Here's the manual. Look at page 6-8. That tells how to turn on real-time transmission. You just need to do the same thing, except switch it to off when you get to that step. http://www.brother.ca/en/products/pdf/manuals/MFC8220-UG.pdf