No power an it pulg in - Acer Computers & Internet

Probably the power is not received by the heating coil, check fuse near the power cable (inside the flap on the iron bottom), or sometimes there is fuse in the power pulg of the power chord. It is rarely that the lamp is blown

change your spark pulgs, pulg wires, air filter, and fuel filter. that would be a good start now do you want to know step by step or what to change

let me know
stockam auto

If you need further help, reach me via phone at https://www.6ya.com/expert/dennis_f849d3d6a68c6430

The processor could be locked up on it, or the power supply needs replaced, or electrlytic caps need change out on the power supply. That TV goes to off mode when it is pulg in, I don't think that there was any damage by pulging it in. Leave it unplug for 40Min., and that will reset the processor back to normal.

Give Royal a call at 1-800-524-0799 for parts assistance.

Nothing.... You have power and ground the third one is NOTHING

If there is no power to the plug, then either the coil is bad, or the stator that turns and gives power to coil is bad.

there is always possibility but the chance is low, even equipments fail under normal operation, dont' worry about it

check the connector of the pulg

remove the battery and agian fix it in your laptop you get it and with him power adpater pulg on it

Replace the H.O.T. (Horizontal Output Transistor)