Question about Master Bilt Commercial Freezer 860610

2 Answers

HOW CAN I GET A REPLACEMENT MOUNTING BRACKET FOR THE INSIDE BLOWERS THAT BOLT TO THE BACK OF THE MOTOR. THERE ARE 3 ON EACH MOTOR AND MOUNTS TO THE FRONT OF THE EVAPERATOR. MODEL #SE36-120B-D , SER,# E08M45749005001. THIS HAS A HEART TRANSFER PRODUCT NAME FROM SCOTTSBORO. AL. THE EVAPERATOR ALSO HAS A #SA2286. I HAVE BEEN TOLD THEY ARE NOT AVALIABLE. HARD TO BELEIVE.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The information I found was based on a unit I have M/N SA2286 and a secondary M/N SE46-185B-E. The latter M/N appears to be a Witt model number. See link: http://www.hillphoenix.com/tyler/mechanical/witt_superflo_411.pdf

Posted on Jul 13, 2016

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 83 Answers

Master Bilt are usually pretty good, try this link and talk to the spares/ service guys

http://www.master-bilt.com/comdir/direct.htm

Hope this helps

Posted on Apr 14, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is causing Scotsman icemaker to moan


perhaps it's unhappy? I can't say i blame it, if I had to sit there all day in the freezing cold making ice I would moan too.
here's a list of possible problems
If it makes excessive noise:-
Problem and Likely Causes/ Probable Solutions

Fan blade vibrates Blade is bent Replace fan blade

Fan motor mount is broken Replace motor mount

Compressor vibrates Mounting loose Check mounting

Water pump vibrates Pump bearings worn Replace pump

Panels vibrate Mounting screws loose Tighten screws

and ice can groan as it expands, but that only applies to large icebergs

May 14, 2014 | Scotsman Freezers

1 Answer

How To Replace Relay On True T-72 Reachin


If it's mounted inside a box along with the capacitors there is 1 screw holding it from the back. Often you have to unmount the box from the compressor to access the screw.

Apr 04, 2012 | True 72 cu. ft. / 2039 liter Commercial...

1 Answer

Have a True Freezer. It will kick on but when shutting down it shakes like crazy


This can be due to poor mounting of teh compressor. If the freezer is old then the mounting bushes can be worn out and must be replaced. Also check on the mounting bolts as if these are loosely fitted the compressor will ******** moe specially when the motor stops due to the force.

Jan 04, 2012 | True Freezers

1 Answer

I need a compressor fan for a model 406-995 .where can I get one?


I had the same problem, and the local repair places could not find an exact replacement part, one of the repair shops had a fan from another unit and i just swapped the mounting bracket and wired it in.

Jan 18, 2010 | Caravell 5.5 cu. ft. / 156 liter Chest...

1 Answer

The motor in my freezer makes a very loud noise and sounds like it is trying to start, it takes a few seconds before it stops the noise, then starts running the freezer.


That's usually mounts inside the compressor. It could still last awhile so if you can put up with the noise just wait for it to quit before replacing the compressor or getting a new fridge.

Oct 27, 2009 | Kenmore 13.7 cu. ft. / 388 liter Upright...

1 Answer

Hi, freezer is cold at bottom , circulating fan is not working.


Hi Guys, I tested fan removed(to 240vlts) neg- pos to wires+earth to mount bracket, and found to be working, reinstalled and found power - active to both wires??fan cut out (defrost mode)activated by timer control, my timer control ( bottom rear near motor) has a knob, so i turned it and fan started,continous turning knob ran thru all cycles defrost,fan start, etc: obviously timer control was faulty, To save frozen goods , i set control to run and installed a power point timer to cycle freezer till new switch arrives, taking the place of faulty controller...

Oct 23, 2009 | Electrolux Freezers

1 Answer

Everything seems to be workin but i have a wierd noise coming from inside the freezer


The evaporator fan is behind the rear cover inside the freezer. It could be hitting ice or the mounting bracket.

Aug 18, 2009 | Frigidaire Freezers

4 Answers

Maytag upright freezer model MQU1556AEW


I experienced the same problem last week with my freezer. Apparently the change in temperature during defrosting allows the blade locking mechanism to slide on the motor shaft during the spinning operation. The blade pulls itself along the shaft until it comes in contact with the motor mounting bolt. If your freezer just stops getting super cold, but remains cool and you don't hear the fan spinning, remove the inside back panel and check the fan blades for freedom of movement. I almost disposed of the freezer this past week but decided to make one last check of the mechanisms.

Sep 22, 2008 | Freezers

2 Answers

Potential relay mounting diretion


possibly to avoid the possibility of water pooling on top of it and thus allowing the water to seep inside of the relay and kill it.

Feb 07, 2008 | Freezers

Not finding what you are looking for?
Master Bilt Commercial Freezer 860610 Logo

Related Topics:

324 people viewed this question

Ask a Question

Usually answered in minutes!

Top Master Bilt Freezers Experts

Dennis Boxerman

Level 3 Expert

1033 Answers

AJMAL KHAN

Level 2 Expert

382 Answers

John Tripp
John Tripp

Level 3 Expert

4654 Answers

Are you a Master Bilt Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...