Question about SDAT SG-80DC Motherboard

1 Answer

Reboots a lot or at a slight bump - SDAT SG-80DC Motherboard

Posted by Anonymous on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Probably a loose power connector or malfunctioning PSU.

Posted on Mar 27, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My cellphone (HTC One X) keeps turning off and on. Any ideas why?

HTC cell phones do that quite often. It can happen because of fast temperature change.
Another reason for this might be slight bumps recently.
If you have updated your version of Android, there could have been an error, so your device is trying to fix it by rebooting.

I strongly suggest you to bring your phone to the service center for diagnostic.

Apr 09, 2016 | Cell Phones

1 Answer

What could be causing the loud shrieking noise on spin only? It's also making a little bumping noise - not a lot, but it's there.

It is usually the bearings that cause the shrieking noise if you have a belt on it it could be needing straightened on the pulley and if you take the belt off and try and turn the drum and listen to see if it is the bearings slightly grinding they may have got water into them. The only other unit is the motor. The bumping noise can be caused if maybe a sock or something that can get between the drum and the casing also some washing machines have shockers and some have springs on top that can break through time and wear and this causes it to be unbalanced.

Mar 14, 2016 | Washing Machines

1 Answer

Had a slight bump now power up blue lights but black screen

One older laptop there is a rubber bump switch to tell the cover is up or down. (or stuck in the middle)

The micro switch is on the bottom of the screen.

Jan 19, 2014 | Computers & Internet

1 Answer

My hs-125 scooter stops when it hits a slight bump

There are only two reasons why your scooter would stop when you hit a slight bump...(1) loss of spark and or (2) loss of fuel
More info needed...does it start back up or do you have to crank a lot?
or do you mean "it stops like the brake is on?

Feb 02, 2013 | Ctm HS 125 3 Wheel Power Scooter

1 Answer

How to jump start a honda rebel

As far as I can tell it can be "bump started" there are a lot of videos on line about bump starting a motorcycle by putting it into 2nd gear on a slight hill then with the clutch in get it moving when you get up to about 10 MPH letting the clutch out

Feb 02, 2013 | Honda Motorcycles

1 Answer

Everytime I turn a corner or go over a bump the entire system shuts off and reboots. It will do this mutliple times, to the point where its no longer playing music anymore. What's wrong with it?

I would check fusable link on power supply 12 volt DC from battery voltage. if compression springs loose inside link, possible that bumps are causing loss of contact causing power down, then when the reconnect, you get reboot, check entire power supply line from point of power connection to unit.

DW Mylin

Nov 28, 2012 | Kenwood Kdc-138 Car Cd Receiver Aux Ipod...

1 Answer

Remove bump

Press and hold on the bump icon. After a few seconds the icon should begin to wiggle slightly and an "X" icon will appear at the top left. Tap the x and the bump app will be deleted from your iPhone.

Jun 07, 2012 | Bump Technologies Bump

2 Answers

Ultrasharp 1800fp monitor will not turn on


Apr 12, 2010 | Dell UltraSharp 1800FP 18.1" LCD Flat...

2 Answers

Power light on and beeping and no picture acer aspire t180

If your computer beeps when you turn it on you have a problem with your power supply, system board, graphics/video card or keyboard.
Reboot your system with out the keyboard if it no longer beeps your problem is a couple of stuck keys on the keyboard.
If the beeping continues remove your graphics card and reboot your system.
If your pc still beeps the it is either your power supply or the system board.

Jan 10, 2010 | Acer Aspire T180 PC Desktop

Not finding what you are looking for?
SDAT SG-80DC Motherboard Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top SDAT Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18425 Answers

Alun Cox

Level 3 Expert

2678 Answers

David Payne
David Payne

Level 3 Expert

14162 Answers

Are you a SDAT Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides