Question about GE 24 in. GSD6660GSS Built-in Dishwasher

1 Answer

GE built in dishwasher

My GE diswasher that is only 1 year new, does not stop running. I start it at 1pm and it ends at 7pm, the countertop gets really hot and the soap does not seem to dispense. Any idea why? something I can do before placing a $200 service call?
thankyou

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 166 Answers

YOU ARE UNDER WARRANTY SERVICE FOR ONE YEAR!
And if your a week over or a little bit, GE will still make good on it! Do not wait! Monday call GE! Why is it $200 for service call?
$75 is what we pay!
look for a new guy if they want here in fixya.com are service people,
too! Don't run this. it is a fire hazard if it's doing this!
Bless you

Posted on Sep 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ge diswasher wont drain


So you have an airgap ? if you might have a clog . if you are not sure dind were your drain hose runs to . usally it is under your sink cabinet , you can unhook the end of the drain hose and put in a large bucket and dorce drain your dishwasher. if no luck take the filter screen out from the bottom inside and look for broken glass or whatever would prevent a drain. oh get a wet vac to remove water so you can see what you are looking for. Also listen for a hum when you force drain if you do not hear anything call for service, pump is dead or not getting voltage

Feb 16, 2013 | GE ADW1100N Built-in Dishwasher

1 Answer

I have Frigidaire FDB956RBC1 diswasher. I have to turn off the water to fix the faucet. When I turned the water back on, water did not go to the diswasher when I used it. The diswasher runs normal except...


FRIDG... EXPERT HERE

Welcome to fixya

Hello


I have a solution for this


Press Ok, Accept or replay so we may get started


Your pre-solution is coming up shortly


PLEASE REPLY OR LEAVE COMMENT TO CONFIRM YOU RECEIVED THIS EMAIL


My name is Bruce

Jan 19, 2011 | Frigidaire FDB956RB Built-in Dishwasher

1 Answer

GE Nautilus built-in dishwasher suddenly won't spray


micro switch at the door lock has failed. it just happened to me.
I wired it direct and it worked. just dont open the door until you get a new switch. it wont shut off

Jul 11, 2010 | GE Nautilus 24" Built-in Dishwasher

1 Answer

Not draining water


You need to replace the piston assembly check valve (see http://www.repairclinic.com/SSPartDetail.aspx?s=t-gsd5500g-%3d%3di821081&PartID=821081). This part is beneath the rear filter frame. You then twist it out. In my dishwasher the little rubber valve piece had completely disintegrated. That allows water to be pumped back into the dishwasher rather then being emptied out the drain house. I replaced the little rubber piece with a piece of plastic cut from a milk jug bottle cap. My first attempt wore out after about a year. I just replaced it again. Works like a champ. Or you can just order the part you need from repairclinic.com

May 31, 2010 | GE 24 in. GSD5500G - Multiple Color...

2 Answers

The clean light is blinking diswasher won't start


Push these buttons in this order High temp wash > Heated dry>High temp wash >Heated dry all the lights will come on and this will reset the board and run it through a short test cycle but more than likely it will come up again,It's a failure in the heating cycle either the heater itself or the turbidity sensor which sits mounted up into the tub right behind the drain pump...hope this helps

Sep 13, 2009 | Whirlpool GU2400XTP Built-in Dishwasher

1 Answer

I have a ge nautilus built in dishwasher and do not know the model number it is 7 years old and came with house. need to replace and am unsure of dimensions for correct sizing on new purchase


You can find them on a label on the tub wall just inside the door. However 99% of all DW are a standard size and the difference is made up by adjustments of the threaded leveling /adjustment legs.

Standard size is 24" x 32-36"...you can take a tape measure and measure from the floor to the bottom of the countertop it is to be installed under...and then measure across the front of the DW. you should find my measurements to be within this range unless it is a custom unit.

Hope this helps. ...good luck and good day...The Fang

Mar 18, 2009 | GE Nautilus 24" Built-in Dishwasher

1 Answer

Ge dishwasher not drying


1 make sure heated dry is on.
2 run your cycle and when it says drying open the dishwasher. see if it has steam coming out.
3 give me your whole model number.
4. if heater is not turning on then you may have one of three issues.
1. Bad door switch
2. Wire off element or bad thermistat
3. No power going through the control. to the heating circuit.

Jan 07, 2009 | GE ADW1100N Built-in Dishwasher

1 Answer

Replacing an old diswasher


all dws are standard hight

Dec 24, 2008 | GE Dishwashers

1 Answer

Replacement for an old diswaher


all dishwashers, with few wxception are made to a standard width and height. but you would take the from the floor to underside of counter.

Dec 24, 2008 | GE Dishwashers

2 Answers

Not cleaning the dishes


You need to check your water temp after it enters the diswasher, it should be at least 120 deg when it get in the dishwasher. If it not then the detergent, food, and greese can't break down.

Jun 20, 2008 | GE 24 in. Profile PDW9880JSS Built-in...

Not finding what you are looking for?
GE 24 in. GSD6660GSS Built-in Dishwasher Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Dishwashers Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

Are you a GE Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...